User manual PIONEER DEH-P510UB

[. . . ] Also, never connect it to the power terminal of the auto antenna. Otherwise, battery drain or malfunction may result. This cable and other product's ground cable (especially, high-current products such as power amp) must be wired separately. [. . . ] In another type of vehicle, never connect 6* and 7*. note: Depending on the kind of vehicle , the function of 3* and 5* may be different. In this case, be sure to connect 2* to 5* and 4* to 3*. Cap (1*) Do not remove cap if this terminal is not in use. ISO connector Note: In some vehicles, the ISO connector may be divided into two. In this case, be sure to connect to both connectors. When using a subwoofer of 70 W (2 ) , be sure to connect with Violet and Violet/black leads of this unit. Do not connect anything with Green and Green/black leads. Yellow/black If you use an equipment with Mute function, wire this lead to the Audio Mute lead on that equipment. Leave ample space When installing in a shallow space, use a supplied mounting sleeve. If there is enough space behind the unit, use factory supplied mounting sleeve. Secure the mounting sleeve by using a screwdriver to bend the metal tabs (90°) into place. When reattaching the trim ring, push the trim ring onto the unit until it clicks. (If the trim ring is attached upside down, the trim ring will not fit properly. ) · It becomes easy to remove the trim ring if the front panel is released. When reattaching the trim ring, push the trim ring onto the unit until it clicks. (If the trim ring is attached upside down, the trim ring will not fit properly. ) · It becomes easy to remove the trim ring if the front panel is released. [. . . ] Insert the supplied extraction keys into both sides of the unit until they click into place. Determine the appropriate position where the holes on the bracket and the side of the unit match. Use either truss screws (5 mm × 8 mm) or flush surface screws (5 mm × 9 mm), depending on the shape of screw holes in the bracket. [. . . ]