User manual PIONEER DEH-P6100BT

[. . . ] Speakers connected to this unit must be highpower types with minimum rating of 45 W and impedance of 4 to 8 ohms. Connecting speakers with output and/or impedance values other than those noted here may result in the speakers catching fire, emitting smoke, or becoming damaged. When this product's source is switched ON, a control signal is output through the blue/white lead. When an external power amp is being used with this system, be sure not to connect the blue/white lead to the amp's power terminal. [. . . ] To avoid short-circuiting, cover the disconnected lead with insulating tape. Especially, insulate the unused speaker leads without fail. There is a possibility of short-circuiting if the leads are not insulated. If this unit is installed in a vehicle that does not have an ACC (accessory) position on the ignition switch, the red lead of the unit should be connected to a terminal coupled with ignition switch ON/OFF operations. If this is not done, the vehicle battery may be drained when you are away from the vehicle for several hours. 7 When not connecting a rear speaker lead to a Subwoofer front output Refer to a Handsfree Telephone unit's manual (sold separately). Rear output Antenna jack This product Multi-CD player (sold separately) IP-BUS cable Subwoofer output or Non Fading Output IP-Bus input (Blue) Connecting cords with RCA pin plugs (sold separately) Power amp (sold separately) Power amp (sold separately) Yellow/black If you use a cellular telephone, connect it via the Audio Mute lead on the cellular telephone. If not, keep the Audio Mute lead free of any connections. Brown White/yellow + Front speaker Yellow To terminal always supplied with power regardless of ignition switch position. Rear speaker With a 2 speaker system, do not connect anything to the speaker leads that are not connected to speakers. Subwoofer Perform these connection when using a different amp (sold separately). Use only the parts included with the unit to ensure proper installation. The use of unauthorized parts can cause malfunctions. Consult with your nearest dealer if installation requires the drilling of holes or other modifications of the vehicle. Install the unit where it does not get in the driver's way and cannot injure the passenger if there is a sudden stop, like an emergency stop. The semiconductor laser will be damaged if it overheats, so don't install the unit anywhere hot -- for instance, near a heater outlet. If installation angle exceeds 60° from horizontal, the unit might not give its optimum performance. For horns or lights requiring ground trigger · Insert the release pin into the hole in the bottom of the frame and pull out to remove the frame. This unit can be properly installed either from "Front" (conventional DIN Front-mount) or "Rear" (DIN Rear-mount installation, utilizing threaded screw holes at the sides of unit chassis). for details , refer to the following illustrated installation methods. Insert the supplied extraction keys into the unit, as shown in the figure, until they click into place. Keeping the keys pressed against the sides of the unit, pull the unit out. [. . . ] Keeping the keys pressed against the sides of the unit, pull the unit out. Brown Factory Door Switches RELAY (sold separately) Holder After inserting the holder into the dashboard, then select the appropriate tabs according to the thickness of the dashboard material and bend them. (Install as firmly possible using the top and bottom tabs. Separately sold pin switches are available that can be used to protect your vehicle's trunk, hood etc. [. . . ]