User manual PIONEER DEH-P6950IB

[. . . ] If you ground the products together and the ground becomes detached, there is a risk of damage to the products or fire. If the RCA pin jack on the unit will not be used, do not remove the caps attached to the end of the connector. Speakers connected to this unit must be highpower types with minimum rating of 45 W and impedance of 4 to 8 ohms. Connecting speakers with output and/or impedance values other than those noted here may result in the speakers catching fire, emitting smoke, or becoming damaged. [. . . ] When an external power amp is being used with this system, be sure not to connect the blue/white lead to the amp's power terminal. Likewise, do not connect the blue/white lead to the power terminal of the auto-antenna. To avoid short-circuiting, cover the disconnected lead with insulating tape. Especially, insulate the unused speaker leads without fail. There is a possibility of short-circuiting if the leads are not insulated. If this unit is installed in a vehicle that does not have an ACC (accessory) position on the ignition switch, the red lead of the unit should be connected to a terminal coupled with ignition switch ON/OFF operations. If this is not done, the vehicle battery may be drained when you are away from the vehicle for several hours. Antenna jack Multi-CD player (sold separately) IP-BUS cable Connecting cords with RCA pin plugs (sold separately) This Product Subwoofer output or Non-Fading output Blue/white To system control terminal of the power amp or Auto-antenna relay control terminal (max. Yellow/black If you use a cellular telephone, connect it via the Audio Mute lead on the cellular telephone. If not, keep the Audio Mute lead free of any connections. Cords for this product and those for other products may be different colors even if they have the same function. Use only the parts included with the unit to ensure proper installation. The use of unauthorized parts can cause malfunctions. Consult with your nearest dealer if installation requires the drilling of holes or other modifications of the vehicle. Install the unit where it does not get in the driver's way and cannot injure the passenger if there is a sudden stop, like an emergency stop. The semiconductor laser will be damaged if it overheats, so don't install the unit anywhere hot -- for instance, near a heater outlet. If installation angle exceeds 60° from horizontal, the unit might not give its optimum performance. Strap Be sure to use the strap to secure the back of the unit in place. For horns or lights requiring ground trigger · This unit can be properly installed either from "Front" (conventional DIN Front-mount) or "Rear" (DIN Rear-mount installation, utilizing threaded screw holes at the sides of unit chassis). 6 Insert the release pin into the hole in the bottom of the frame and pull out to remove the frame. Holder After inserting the holder into the dashboard, then select the appropriate tabs according to the thickness of the dashboard material and bend them. (Install as firmly as possible using the top and bottom tabs. [. . . ] Insert the supplied extraction keys into the unit, as shown in the figure, until they click into place. Keeping the keys pressed against the sides of the unit, pull the unit out. Separately sold pin switches are available that can be used to protect your vehicle's trunk, hood, etc. When you purchase these, make sure that you first confirm that they can be used with your vehicle's door system type. [. . . ]