User manual PIONEER DEH-P7200HD

[. . . ] Please ground this lead separately from the ground of high-current products such as power amps. If you ground the products together and the ground becomes detached, there is a risk of damage to the products or fire. If the RCA pin jack on the unit will not be used, do not remove the caps attached to the end of the connector. Speakers connected to this unit must be highpower types with minimum rating of 45 W and impedance of 4 to 8 ohms. [. . . ] Perform these connections when using a different amp (sold separately). 7 When using a Subwoofer without using a different amp (sold separately) Front output ASL unit Rear output Antenna jack Multi-CD player (sold separately) IP-BUS cable Subwoofer output This Product Yellow/black If you use a cellular telephone, connect it via the Audio Mute lead on the cellular telephone. If not, keep the Audio Mute lead free of any connections. Yellow To terminal always supplied with power regardless of ignition switch position. Do not connect anything to these speaker leads. Because of the complexity of today's technically advanced vehicle wiring systems, we recommend that your DFS Alarm be installed ONLY by a professional Pioneer installer. Install the unit so that it can be quickly disconnected in case the engine doesn't start even if the unit operates correctly. (Refer "STARTER CUT-OFF" , "Avoiding Trouble" section. ) Affix the included deterrent stickers to the inside of the front door windows. This lead is used to trigger DFS Alarm when any door is opened and may be connected to either positive or negative (+/­) type door pin switches. This lead is a selectable constant or pulsed positive (+) output capable of driving up to 2 relays (500 mA) max. If you have difficulty wiring this connection, please consult your nearest Installation specialist. If your vehicle is equipped with a central door lock but the glass or shock sensor is not connected, if the window is broken and the central door lock is released, this unit's DFS Alarm will not operate. Pioneer recommends that both a shock sensor and glass sensor be installed when you are using the "Remote Disarming" feature. The blue/brown lead will provide a continuous +12 V output while alarm is sounding and for 30 minutes after initial trigger, up to 5 consecutive triggers. This lead has a maximum current capability of 500 mA and can be used to trigger a relay to disable the starter. In order for the "DFS Alarm" to operate when a window is broken, connect this product's white/red (ALARM SENSOR) lead to glass sensor securely. In order for the "DFS Alarm" to operate when a door is forced open, connect this product's white/yellow (DOOR SWITCH) lead securely. Cut starter wire and try to start vehicle to verify wire is correct. Connect key side of cut wire to normally closed pin. Connect starter side of cut wire to common pin. You may not be able to start the engine even if you operate the unit correctly. [. . . ] Strap Be sure to use the strap to secure the back of the unit in place. 6 Insert the release pin into the hole in the bottom of the frame and pull out to remove the frame. Insert the supplied extraction keys into the unit, as shown in the figure, until they click into place. Keeping the keys pressed against the sides of the unit, pull the unit out. [. . . ]