User manual PIONEER DEH-P9200R

[. . . ] Never feed power to other equipment by cutting the insulation of the power supply lead of the unit and tapping into the lead. When replacing fuse, be sure to use only fuse of the rating prescribed on the fuse holder. Since a unique BPTL circuit is employed, never wire so the speaker leads are directly grounded or the left and right speaker leads are common. [. . . ] With a 2 speaker system, do not connect anything to the speaker leads that are not connected to speakers. Perform these connections when using a different amp (sold separately). 7 When using a Subwoofer without using a different amp (sold separately) Because of the complexity of today's technically advanced vehicle wiring systems, we recommend that your DFS Alarm be installed ONLY by a professional Pioneer installer. Affix the included deterrent stickers to the inside of the front door windows. Set DFS Alarm to recognize ground trigger from DFS Alarm Setting Menu. This lead is used to trigger DFS Alarm when any door is opened and may be connected to either positive or negative (+/­) type door pin switches. This lead is a pulsed positive (+) output capable of driving up to 2 relays (500 mA) max. Use this lead to trigger relays for siren, horn, honk or flashing lights. Yellow/black If you use a cellular telephone, connect it via the Audio Mute lead on the cellular telephone. If not, keep the Audio Mute lead free of any connections. After hookup, simply set door system type from DFS Alarm Setting Menu. Domelight Delay-DFS Alarm will wait for last door to close and courtesy light to turn off before Exit Delay Timer Starts. Yellow To terminal always supplied with power regardless of ignition switch position. Fuse holder Do not connect anything to these speaker leads. Set DFS Alarm to recognize positive trigger from DFS Alarm Setting Menu. The brown lead provides a +12 V, pulsed output while alarm is sounding. [. . . ] Select a position where the screw holes of the bracket and the screw holes of the head unit become aligned (are fitted), and tighten the screws at 2 places on each side. Use either binding screws (5 × 6 mm) or flush surface screws (5 × 6 mm), depending on the shape of the screw holes in the bracket. Press the remote control unit onto the mounting base until it clicks into place. [. . . ]