User manual PIONEER DEH-P9600MP

[. . . ] Insert the release pin into the hole in the bottom of the frame and pull out to remove the frame. If you do not operate the removing and attaching the front panel function, use the supplied fixing screws to fix the front panel to this unit. Holder After inserting the holder into the dashboard, then select the appropriate tabs according to the thickness of the dashboard material and bend them. (Install as firmly as possible using the top and bottom tabs. [. . . ] ISO connector Note: In some vehicles, the ISO connector may be divided into two. In this case, be sure to connect to both connectors. Yellow/black If you use a cellular telephone, connect it via the Audio Mute lead on the cellular telephone. If not, keep the Audio Mute lead free of any connections. Speaker leads White : High range left + White/black : High range left Gray : High range right + Gray/black : High range right Green : Middle range left + Green/black : Middle range left Violet : Middle range right + Violet/black : Middle range right Perform these connections when using the optional amplifier. Perform these connections when using the optional amplifier. This unit is for vehicles with a 12-volt battery and negative grounding. before installing it in a recreational vehicle , truck , or bus , check the battery voltage. To avoid shorts in the electrical system, be sure to disconnect the battery cable before beginning installation. Refer to the owner's manual for details on connecting the power amp and other units, then make connections correctly. secure the wiring with cable clamps or adhesive tape. To protect the wiring, wrap adhesive tape around them where they lie against metal parts. Route and secure all wiring so it cannot touch any moving parts, such as the gear shift, handbrake and seat rails. Do not route wiring in places that get hot, such as near the heater outlet. If the insulation of the wiring melts or gets torn, there is a danger of the wiring short-circuiting to the vehicle body. Don't pass the yellow lead through a hole into the engine compartment to connect to the battery. This will damage the lead insulation and cause a very dangerous short. If you do, the protection circuit may fail to work when it should. [. . . ] If not, keep the Audio Mute lead free of any connections. Speaker leads White :Front left + White/black :Front left Gray :Front right + Gray/black :Front right Green :Rear left + Green/black :Rear left Violet :Rear right + Violet/black :Rear right 26. In another type of vehicle, never connect 6* and 7*. Perform these connections when using the optional amplifier. [. . . ]