User manual PIONEER DEQ-P7000

[. . . ] Thank you for buying this Pioneer product. Please read through these operating instructions so you will know how to operate your model properly. After you have finished reading the instructions, put them away in a safe place for future reference. Before You Start About this unit 3 · Dolby Digital/DTS compatibility (when combining this unit with a Pioneer DVD player such as DVH-P7000R) 3 About this manual 3 Precautions 3 In case of trouble 3 Resetting the microprocessor 4 Output setting of the DVD player 4 What's what 5 · This product complies with the EMC Directives (89/336/EEC, 92/31/EEC) and CE Marking Directive (93/68/EEC). [. . . ] lARGE (large)--SMALL (small)--OFF (off) · You cannot select OFF, when the front speakers have been selected. You can switch ON or OFF, when the subwoofer has been selected. If trying to boost the bass output of the subwoofer doesn't do much or rather makes you feel that the bass gets more murky, this may indicate that the subwoofer's output and bass content you hear over other speakers cancel each other out. To remove this problem, try changing the phase setting for the subwoofer. You need to make with/without (or yes/no) and size (bass reproducing capacity) selection/adjustments depending on the installed speakers. The size needs to be set to LARGE (large) if the speaker is capable of reproducing sounds of about 100 Hz or below. Each press of 2 or 3 selects the speaker in the following order: Front speakers--Center speaker--Rear speakers--Subwoofer--S. Low frequency range is not outputted if the subwoofer is set to OFF and the front and rear speakers set to SMALL or OFF. When playing a 2-channel mono source with Pro Logic switched on, there may be occasions when the following will occur: No audio is outputted if the center speaker setting is SMALL or LARGE while no center speaker is installed. Audio is heard only over the center speaker if installed and the center speaker setting is SMALL or LARGE. 1 Press AUDIO and hold until SP Set appears in the display, then press AUDIO to select CutOff. After SP Set is displayed, press AUDIO until CutOff appears in the display. 2 Press 2 or 3 to select the cut-off frequency. Each press of 2 or 3 selects the cut-off frequency in the following order: 63--80--100--125--160--200 (Hz) · You can readjust the speaker output levels once adjusted using a test tone while listening to music at the time. 1 Press AUDIO and hold until SP Set appears in the display, then press AUDIO to select SP Lev. After SP Set is displayed, press AUDIO until SP Lev appears in the display. You can select a frequency, under which sounds are reproduced through the subwoofer. If the installed speakers include one whose size has been set to SMALL, you can select a frequency, under which sounds are reproduced through a LARGE speaker or subwoofer. Each press of 2 or 3 selects the speaker in the following order: Front speaker left--Center speaker--Front speaker right--Rear speaker right--Rear speaker left--Subwoofer · You cannot select speakers whose size is set OFF. To adjust the speaker output levels at this mode is the same as making the speaker output levels at T Tone. It rotates from speaker to speaker in the following sequence at intervals of about 2 seconds. The current settings for the speaker over which you hear the test tone are shown in the display. [. . . ] (If the audio speakers other than the center one. Source is mono and Dolby Pro Logic is switched on, sound is heard over the center speaker only. The currently reproduced sound is not Dolby Digital coded. Symptom No sounds come from the DVD player only. [. . . ]