User manual PIONEER DEQP6600

[. . . ] using the down-mix function Using the Dolby Pro Logic B Selecting the time alignment adjustment mode Using the auto-equalizer Auto TA and EQ (auto-time alignment and auto-equalizing) Resetting the audio functions !If DVH-P7000R, DVH-P5000MP or AVHP6500DVD is connected to this unit, operation of following function is limited. Dolby Digital/DTS compatibility When using this unit with a Pioneer DVD player, you can enjoy the atmosphere and excitement provided by DVD movie and music software featuring 5. This unit provides two optical inputs, however, units that can be connected to each input are limited. [. . . ] 0 places all center sound in the center speaker. 7 places all center sound equally in the left/right speakers. # You can switch to PHASE only when the subwoofer has been set to ON. Each time you touch or selects the speaker in the following order: FRONT (front speakers)CENTER (center speaker)REAR (rear speakers) SUB WOOFER (subwoofer)PHASE (subwoofer setting) You need to make with/without (or yes/no) and size (bass reproducing capacity) selection/adjustments depending on the installed speakers. The size needs to be set to LARGE (large) if the speaker is capable of reproducing sounds of about 100 Hz or below. Low frequency range is not output if the subwoofer is set to OFF and the front and rear speakers set to SMALL or OFF. # You cannot select OFF, when FRONT (front speakers) have been selected. # You can select ON or OFF, when SUB WOOFER (subwoofer) has been selected. # You can switch REVERSE (reverse phase) or NORMAL (normal phase), when PHASE (subwoofer setting) has been selected. Each time you touch or selects the size in the following order: OFF (off)SMALL (small)LARGE (large) If trying to boost the bass output of the subwoofer doesnt do much or rather makes you feel that the bass gets more murky, this may indicate that the subwoofers output and bass content you hear over other speakers cancel each other out. To remove this problem, try changing the phase setting for the subwoofer. The center speaker largely determines the sound image and getting the balance right isnt easy. Audio (a CD for example) and getting the balance right among the speakers except for the center, and then reproducing a 5. Audio (Dolby Digital or DTS) and adjusting the center speaker output to the balance you have already got among the other speakers. Each time you touch or selects equalizer bands in the following order: LOW (low)MID (mid)HIGH (high) 6 Touch and then touch or to select the center frequency of selected band. Touch or until the desired frequency appears in the display. Each time you touch or increases or decreases the equalizer level. Each time you touch or switches between the following Q factor: WIDE (wide)NARROW (narrow) # You can adjust parameters for each band of the other speakers in the same way. Note You can select a center frequency for each band. You can change the center frequency in 1/3-octave steps, but you cannot select frequencies that have intervals shorter than 1 octave among the center frequencies of the three bands. This function cannot be operated when DVHP7000R, DVH-P5000MP or AVH-P6500DVD is connected to this unit. The auto-time alignment is automatically adjusted for the distance between each speaker and the listening position. [. . . ] ) (Page 10) Turn Dolby Pro Logic B off. (If the audio source is mono and Dolby Pro Logic B is turned on, sound is heard over the center speaker only. ) (Page 9) The feature is only effective on Dolby Digital sounds. (Page 8) Speakers are not available to be Their size settings is at OFF. [. . . ]