User manual PIONEER DEX-P99R

[. . . ] The RDS (radio data system) function operates only in areas with FM stations broadcasting RDS signals. These symbols on the products, packaging, and/or accompanying documents mean that used electrical and electronic products and batteries should not be mixed with general household waste. For proper treatment, recovery and recycling of old products and used batteries, please take them to applicable collection points in accordance with your national legislation. By disposing of these products and batteries correctly, you will help to save valuable resources and prevent any potential negative effects on human health and the environment which could otherwise arise from inappropriate waste handling. For more information about collection and recycling of old products and batteries, please contact your local municipality, your waste disposal service or the point of sale where you purchased the items. CAUTION ! [. . . ] Refer to Adjusting initial settings on page 38. 2 Press MULTI-CONTROL to turn the face auto open on. # To turn the face auto open off, press MULTI-CONTROL again. Adjusting the brightness You can adjust the display brightness. 1 Use MULTI-CONTROL to select Brightness in the initial setting menu. Refer to Adjusting initial settings on page 38. 2 Push MULTI-CONTROL left or right to adjust the brightness level. 0 to 15 is displayed as the level is increased or decreased. # When dimmer is functioning, the brightness level can be adjusted 0 to 10. Switching the auxiliary setting Auxiliary devices connected to this unit can be activated individually. For more information about connecting or using auxiliary devices, refer to Using the AUX source on page 45. 1 Use MULTI-CONTROL to select AUX1/ AUX2 in the initial setting menu. Refer to Adjusting initial settings on page 38. Selecting the illumination color You can select the illumination color from among White, Red, Amber, Green and Blue. Also, you can adjust brightness of each color. 1 Use MULTI-CONTROL to select Illumination 1 in the initial setting menu. Pressing MULTI-CONTROL repeatedly will switch between High (high) and Low (low) and that status will be displayed. Resetting the audio functions You can reset all audio functions. 1 Use MULTI-CONTROL to select Audio Reset in the initial setting menu. Refer to Adjusting initial settings on page 38. appears in the display. Setting the illumination interlock This unit's button illumination can be interlocked with either the ignition key or the vehi- En 41 Section 04 Initial Settings 3 Push MULTI-CONTROL right. 4 Press MULTI-CONTROL to reset audio functions. Complete appears in the display and audio functions are reset. # To cancel this function on the way, press B. 2 Press MULTI-CONTROL to select setting. Each press of MULTI-CONTROL selects settings in the following order: High (high)--Low (low) !If the polarity changes to + (positive) when the door is opened, select High. If the polarity changes to ­ (negative) when the door is opened, select Low. Switching the sound muting/attenuation Sound from this system is muted or attenuated automatically when the signal from the equipment with mute function is received. The sound is muted or attenuated, MUTE or ATT are displayed and no audio adjustment is possible. Sound from this system returns to normal when the muting or attenuation is canceled. [. . . ] MPEG-4 AAC (iTunes encoded only) (. m4a) (Ver. 7. 7 and earlier) WAV signal format . . . . . . . . . . . . . . . . . . Linear PCM & MS ADPCM (Non-compressed) USB USB standard specification . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . USB 2. 0 full speed Maximum current supply . . . . [. . . ]