User manual PIONEER DJM-250-W

[. . . ] Com/support/ The Pioneer website shown above offers FAQs, information on software and various other types of information and services to allow you to use your product in greater comfort. а а а а а , , а а а а Operating Instructions Mode d’emploi Bedienungsanleitung Istruzioni per l’uso Handleiding Manual de instrucciones И а а Thank you for buying this Pioneer product. Please read through these operating instructions so you will know how to operate your model properly. After you have finished reading the instructions, put them away in a safe place for future reference. [. . . ] 9 PHONO /LINE CD PHONO /LINE TRIM a b 9 c HI MASTER CH-1 CH-2 OVER 9 HI a b 9 OVER 9 MID EQ d 9 +4 +2 0 -6 -12 -18 dB +4 +2 0 -6 -12 -18 dB d MID EQ 9 6 Turn the [MASTER LEVEL] control 1 clockwise. The master level indicator c on the control panel lights. Adjust [MASTER LEVEL] so that the orange indicator lights at the point in the track where the volume is loudest (the climax, etc. Be careful that the red indicator does not light, or the sound could be distorted. 1 LOW LOW 2 9 9 LEVEL SOUND COLOR FILTER LPF HPF LPF HPF Adjusting the sound quality Turn the [CH-1] 1 or [CH-2] 2 EQ (HI, MID, LOW) control b. Refer to Specifications on page 14 for the range of sound that can be adjusted by each control. The sound for that range can be turned completely off by turning the control all the way counterclockwise (isolator function). E CH-1 CH-2 f Mixing using the faders Prepare the unit in advance so that the sound of [CH-1] 1 is being output from the speakers. For instructions on preparation, see Outputting sound on page 10. Outputting sound Check that this unit is properly connected to the DJ player, etc. For instructions on connections, see Connecting the input/output terminals on page 6. Set the volume of the powered speakers connected to the [MASTER 1] and [MASTER 2] terminals to a suitable level. Note that sound will be output at a high volume if the volume is set too high. For instructions on monitoring the sound, see Monitoring the sound over headphones (headphones section) on page 12. 4 Press the [CH-2] button 5 in the headphones section. The sound of [CH-2] is monitored from the headphones.  To output the sound of channel 1 [CH-1] 1 To output the sound of channel 2 ([CH-2]) 2, perform the procedure below replacing [CH-1] with [CH-2]. Adjust the monitor volume balance of the sound output from the [MASTER 1] or [MASTER 2] terminals (the [CH-1] sound) and the [CH-2] sound. 1 Switch the [CH-1] 1 [CD , PHONO/LINE] input selector switch 9. Select the input source for [CH-1] from among the devices connected to this unit. € [CD]: Selects the DJ player connected to the [CD] terminals. € [PHONO/LINE]: Selects the device connected to the [PHONO/LINE] terminals. [. . . ] Sound is distorted when an analog player is connected to this unit’s [PHONO/LINE] terminals. Or, lighting of the channel level indicator does not change even when the [TRIM] control is turned. Have you connected an analog player with a builtin phono equalizer?Set the [ON/OFF] switch for power supply to [ON]. [. . . ]