User manual PIONEER DJM-400

[. . . ] Thank you for buying this Pioneer product. Please read through these operating instructions so you will know how to operate your model properly. After you have finished reading the instructions, put them away in a safe place for future reference. In some countries or regions, the shape of the power plug and power outlet may sometimes differ from that shown in the explanatory drawings. [. . . ] ¶ If the BEAT/BANK button is pressed while holding the ERASE (BEAT/PITCH ­) button depressed, the music sample recorded in the BEAT/BANK button will be erased. Use to select the channel to which beat effects are applied (P. When [MIC] is selected, effects are applied to both microphone 1 and microphone 2. When effects are disabled (OFF), the button lights. When effects are enabled (ON), the button flashes. Whenever power is first turned ON, effects default to OFF. (Adjustable range ­ to 0 dB) When the connection panel's MIC/AUX switch is set to [AUX], this dial adjusts the sound volume for the left channel (AUX(L)). (Adjustable range ­ to 0 dB) When the connection panel's MIC/AUX switch is set to [AUX], this dial adjusts the sound volume for the right channel (AUX(R)). ¶ When the switch is set to [TALK OVER], if a sound is input to the AUX connectors, the output for all sources other than the AUX input is attenuated by 20 dB. Use the channel fader lever to adjust the sound volume of the selected channel. To use the cross fader on the selected channel, set the cross fader selector switch to either the middle position ( ) or the right position ( ), then operate the cross fader lever. ¶ When not using the cross fader, set the cross fader selector switch to [THRU]. Use the MIC 1 LEVEL dial to adjust the sound from the L channel, and MIC 2 LEVEL dial to adjust the sound from the R channel. Use the microphone equalizer dial (EQ) to adjust sound tone. Use the MASTER LEVEL dial to adjust the overall sound volume. When the connection panel's STEREO/MONO switch is set to [MONO], the master output becomes a monaural combination of L+R channels. ¶ When the switch is set to [TALK OVER], if sounds of over ­15 dB are detected by the microphone, the output for all sound sources other than the microphone is attenuated by 20 dB. Use the LEVEL dial to adjust the headphones sound level. Use the MIC 1 LEVEL dial to adjust the sound volume of MIC 1, and the MIC 2 LEVEL dial to adjust the sound volume of MIC 2. The sound volume response to fader lever operation can be set to one of two characteristic curves. 7 Use the cross fader selector switch to select the desired cross fader response curve. ¶ At the center position ( ), the curve operates to produce an even, neutral rise throughout the cross fader's movement. [. . . ] No change is produced when dial is turned toward the right side of the center position. Incorrect operations are often mistaken for trouble and malfunctions. If you think there is something wrong with this component, check the points below. Sometimes the trouble may originate from another component. [. . . ]