User manual PIONEER DJM-800

[. . . ] Thank you for buying this Pioneer product. Please read through these operating instructions so you will know how to operate your model properly. After you have finished reading the instructions, put them away in a safe place for future reference. In some countries or regions, the shape of the power plug and power outlet may sometimes differ from that shown in the explanatory drawings. [. . . ] When effects are enabled (ON), the button flashes. The <CH SELECT> indicator lights constantly, and a red frame lights around the number position corresponding to the chosen effect channel selector. AUTO/TAP: [AUTO] lights when the BPM measuring mode is set to AUTO, and [TAP] lights when the BPM measuring mode is set to manual (TAP). ¶ Indicator lights after MIDI start command has been sent. ¶ Indicator goes out after MIDI stop command has been sent. When the beat select buttons (BEAT 2, 3) are pressed, the corresponding beat multiple change is displayed for one second. If the beat select buttons (BEAT 2, 3) are used to designate a value outside the parameter range, the current number will flash but will not change. Unit Display (%/ms): Lights in accordance with the unit used for each effect. When the parameter 1 is between threshold values, the indicator flashes. Although the display includes seven actual indicators, the two ends can also be considered to act as indicators, with the result that a theoretical nine positions can be postulated. When the values are at the two ends, no indicators light. When the STEREO/MONO switch is set to [MONO], the master output becomes a monaural combination of L+R channels. ¶ When the switch is set to [TALK OVER], any time a sound of over ­15 dB is detected by the microphone, the output for all sound sources other than the microphone are attenuated by 20 dB. Use the MIC 1 LEVEL dial to adjust the sound volume of MIC 1, and use the MIC 2 LEVEL dial to adjust the sound volume of MIC 2. Set the connection panel's MIC SIGNAL switch to select whether microphone sounds are output to the booth monitor. ¶ When using CD input or LINE input, the connection panel's DIGITAL/CD switch or DIGITAL/LINE switch must be set to [CD] or [LINE]. ¶ When using a DIGITAL input, the connection panel's DIGITAL/ CD switch or DIGITAL/LINE switch must be set to [DIGITAL]. ¶ When set to the [ADD] position, microphone sounds are output to the booth monitor, and when set to the [CUT] position, microphone sounds are not output to the booth monitor. Use the BOOTH MONITOR dial to adjust the sound volume. ¶ The BOOTH MONITOR dial can be used to adjust the sound volume independently of the MASTER LEVEL dial. Use the channel fader lever to adjust the sound volume of the selected channel. To use the cross fader on the selected channel, set the CROSS FADER ASSIGN switch to either cross fader channel A or channel B, and operate the cross fader lever. [. . . ] If the trouble cannot be rectified even after checking the following items, contact your dealer or nearest PIONEER service center. symptom No power No sound, or sound volume is too low. Connection cables are connected incorrectly, or connections are loose. Clean soiled jacks/plugs before connecting. [. . . ]