User manual PIONEER DRM-3000

[. . . ] Replacement and mounting of an AC plug on the power supply cord of this unit should be performed only by qualified service personnel. This product contains a laser diode of higher class than 1. To ensure continued safety, do not remove any covers or attempt to gain access to the inside of the product. The following caution label appears on your changer. [. . . ] To remove a disc magazine from the changer, pull the handle towards you and pull the magazine from the changer. Whenever a disc magazine is inserted into the changer, its ID will be automatically read in and displayed on the LCD message window within a few seconds. Once the hyper magazine has been inserted partly into the changer, it will be automatically loaded in. If both of these messages appear together in rapid succession, it indicates that a disc magazine has not been correctly inserted, and you should check the magazine to make sure that it has been inserted properly again. Insert discs into a 20-disc hyper magazine and insert the magazine into the changer. 3 Turn the release knob to the horizontal direction to lock the discs into place. When the hyper magazine has been loaded, a unique magazine ID will be displayed together with the record of the locking mechanism. Note that the magazine will be automatically ejected if the changer is unable to read the magazine ID, and that if this happens you should try inserting the magazine again. Release knob Label Lock release Lock Otherwise it may result in damage to the discs. Be careful not to scratch the reflective signal recording surface. ¶ Do not turn a disc magazine upside down while the lock is disengaged. Otherwise it may result in discs falling out of the magazine. Serial numbers are assigned to each of the slots within the changer into which discs may be inserted. Note that these numbers are assigned even when no disc magazine has been inserted, and that for this reason slot numbers never change even when a new disc magazine is inserted. NOTE: Although slot numbers reach as high as `770', this does not mean that as many as 770 discs may be available within the DRM-7000. NOTE: Although slot numbers reach as high as `370', this does not mean that as many as 370 discs may be available within the DRM-3000. First check to make sure that all components have been installed into place and all cables have been connected. If this has been done, close the front and the rear access doors, then the initialization of the changer mechanism will begin. When initialization has been completed, a message like that shown below will be displayed on the LCD message window. The first line of this message is used to indicate the status of the disc changer mechanism, and the second line is used to indicate the installed drive number and to indicate whether or not a disc has been loaded into the drive in question. Drive numbers are assigned in sequence from the lowermost to the uppermost drive. NOTE: If the maximum number of drives appears on the LCD message window is shorter than the number of drives installed, open the rear access door and check the power cables and the changer interface cables to all drives installed. [. . . ] Reinstall the drive in one of these bays or install the additional power supply unit. In system administrator mode, open the access door and take whatever action is required in order to eliminate the error condition. ¶ When installing is not finished, turn the SCSI termination switch to ON and turn the power OFF and ON. ¶ If the SCSI cable is not properly connected, turn off the power. [. . . ]