User manual PIONEER DRM-600

[. . . ] This Class A digital apparatus complies with Canadian ICES-003. This product complies with the EMC Directives (89/336/EEC, amended by 92/31/EEC and D3-4-2-1-9b_En 93/68/EEC). NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. [. . . ] NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. In a domestic environment this product may cause radio interference in which cause the user may be required to take adequate D44-8-5_En measures. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures. Pioneer disclaims all responsibility for any loss of data, or other incidental damages arising from the use or malfunction of this product. Installation of this product requires a high level of technical expertise, and should be undertaken only by professional Pioneer service personnel. ¶ This unit cannot be used together with Power supply unit DRM-PW701 due to drive installation limitations. ¶ Turn off power to the host computer and changer before connecting SCSI cables. Pressing the upper protrusion causes the number to decrement, while pressing the lower protrusion increments the number. Factory default: 6 3 LVD SCSI interface connector Connect using the supplied (or optionally purchased) SCSI Cable (LVD), or supplied SCSI Terminator (LVD). 4 SE SCSI interface connector Connect to the changer's supplied SCSI Cable (SE). Note: Avoid touching the connectors, since faulty connection or damage from static electricity may result. LVD-side: 12 m or less Total length of cables, including those inside the component (when multiple changers are connected, this includes the cables between the changers) SE-side: 3 m or less Total length of cable for each changer, including that internal to the component. Total LVD and SE devices (including changers, but not including host bus adapters) With one changer: 8 max* With multiple changers: 15 max* * The maximum permissible number of changers differs depending on the drive; for details consult your drive Operating Instructions. [. . . ] LVD-side: 12 m or less Total length of cables, including those inside the component (when multiple changers are connected, this includes the cables between the changers) SE-side: 3 m or less Total length of cable for each changer, including that internal to the component. Total LVD and SE devices (including changers, but not including host bus adapters) With one changer: 8 max* With multiple changers: 15 max* * The maximum permissible number of changers differs depending on the drive; for details consult your drive Operating Instructions. Further, the total number of SE devices (including changers): Regardless of the number of changers: 7 max (however, no more than 4 devices per changer) * Due to restrictions on cable lengths, SE drives are to be installed in drive bays 1 ­ 3. [. . . ]