User manual PIONEER DVH-3100UB

[. . . ] -- Never cut the insulation of the power cable of this unit in order to share the power to other equipment. Control signal is output through blue/white cable when this unit is powered on. [. . . ] Be sure to install the display in such a way that it will not obstruct driving. Make sure that wires will not interfere with moving parts of the vehicle, such as the gearshift, parking brake or seat sliding mechanism. If you do, the protection circuit may fail to work properly. Cap (1*) Do not remove cap if this terminal is not in use. Yellow/black If you use an equipment with Mute function, wire this lead to the Audio Mute lead on that equipment. If not, keep the Audio Mute lead free of any connections. This unit cannot be installed in a vehicle that does not have an ACC (accessory) position on the ignition switch. ISO connector Note: In some vehicles, the ISO connector may be divided into two. In this case, be sure to connect to both connectors. Use this unit in other than the following conditions could result in fire or malfunction. Speaker leads White: Front left + White/black: Front left Gray: Front right + Gray/black: Front right Green: Rear left + Green/black: Rear left Violet: Rear right + Violet/black: Rear right In another type of vehicle, never connect 6* and 7*. Connecting to separately sold power amp When using a display connected video outputs Never install the display in a location where it is visible to the driver while driving. In another type of vehicle, never connect 6* and 7*. Perform these connections when using the optional amplifier. [. . . ] Insert the supplied extraction keys into both sides of the unit until they click into place. Determine the appropriate position where the holes on the bracket and the side of the unit match. [. . . ]