User manual PIONEER DVR-230-S (UK)

[. . . ] DVD Recorder DVR-230-S 4. 7 Operating Instructions ® IMPORTANT CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. CAUTION: TO PREVENT THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. D3-4-2-1-1_En-A WARNING This equipment is not waterproof. [. . . ] · See Setting the picture quality/recording time above for detailed instructions. 4 Use the AUDIO button to select the audio channel to record. See Changing audio channels on page 23 for more on this. · When recording in VR mode, if a broadcast is bilingual, both audio channels are recorded, allowing you to switch the audio channel on playback. The only exception to this is when the picture quality is set to XP, in which case you do need to select the audio channel before recording. Follow the instructions below to record a TV program. Recording starts immediately and continues until the disc is full or you stop the recording. AUDIO 1 4 7 2 5 8 3 6 9 0 CH+ 5 Press ì REC to start recording. If you want to set a recording end time, press the ì REC button repeatedly. The recording time increases in 30 minute increments, up to a maximum of twelve hours. The remaining recording time is shown on-screen and in the front panel display. When the recording ends, the recorder automatically switches into standby. · To cancel the set recording time, press ì REC. · If you want to pause recording at any time, press . (If recording in VR mode, a new chapter is started after recording restarts) 6 To stop the recording, press . · If you set the recording time in the previous step, you can still stop the recording anytime by pressing . · Recording will stop automatically when there is no more space on the DVD. ENTER CH­ ì REC REC MODE DVD RECORDER Tip 1 Load a recordable disc. · If you load a new blank DVD-RW disc, the recorder takes a short while to initialize the disc. · During recording you can turn on/off the SCART loop through function. During recording, press the front panel + button to switch to SCART THRU (loop through on), or ­ to switch to SCART NORM (loop though off). Note that you can't switch loop through on if recording from the AV2(INPUT 1/DECODER) or AV1·RGB-TV AV connectors. Also, loop through is automatically reset to off after recording has finished. 2 Use the CH +/­ buttons to select the TV channel to record. The front panel display shows the channel number: PR07 Channel number · While the recorder is stopped, you can also use the number buttons on the remote to select the channel. (For channel 6, press 6 then ENTER; for channel 24, press 2, 4 then ENTER) · If the recorder is stopped, you can also use the +/­ buttons on the front panel to select the channel number. 37 En 06 Recording Direct recording from TV If you connected this recorder to your TV using a SCART cable, and your TV supports Direct Recording, you can record whatever is currently being shown on the TV without having to worry about what channel preset the recorder is on. [. . . ] RCA jacks AV Connectors (21-pin connector assignment) AV connector input/output . . 21-pin connector This connector provides the video and audio signals for connection to a compatible color TV or monitor. PIN no. GND Supplied accessories Remote control . 2 Audio / Video cable (red/white/yellow) . [. . . ]