User manual PIONEER DVR-2810

[. . . ] CAUTION: Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. CAUTION: The use of optical instruments with this product will increase eye hazard. This product complies with the EMC Directives (89/336/EEC, amended by 92/31/EEC and 93/68/ECC). Operation is subject to the following two (2) conditions: ( 1 ) This device may not cause harmful interference ( 2 ) This device must accept any interference received, including interference that Thank you for buying this Pioneer product. [. . . ] Avoid spilling any liquids in to or on the outside of the drive. Condensation ­ Moisture can form in the operating section of the product if the drive is taken from cool surroundings to a room with a warmer temperature. Let the drive stand for one to two hours in the new location before turning it ON. Servicing ­ Opening or removing the cover exposes you to possible electrical shock or other danger. contact a Pioneer authorized service representative for repairing this drive (refer to the enclosed Service & Support Card). About DualDisc Playback ­ DualDisc is a new two-sided disc with one side containing DVD video / audio / etc. content and the opposite side containing non-DVD content such as digital audio material. The non-DVD audio side is not compliant with the CD Audio Specification; therefore, may not play. The DVD side of DualDisc media plays in this unit. For more details about the DualDisc specification, please refer to the disc manufacturer or your retailer. Note: Some discs may not be playable due to different recording formats or the physical condition of the disc at the time of recording or playback. 25" Half-Height built-in type Stereo Audio Output LCD Tilt-Servo Mechanism Horizontal / Vertical orientation Low vibration mechanism by DRA System Supports "Buffer Under Run" protection (CD/DVD) This product will obtain certification under the "Microsoft® Windows® Logo Program" (WHQL) This product complies to RoHS Directive and WEEE Directive Disc Format (Read/Write) DVD single layer/dual layer / 120mm / 80mm disc (horizontal position only) DVD-R (when writing, use only 650nm ­ for General use ­ media) DVD-R Dual Layer DVD-R and Double Layer DVD+R DVD-RW DVD+R DVD+RW DVD-RAM (non-cartridge, Version 2. 1) CD-ROM Mode 1 CD-R XA Mode 2 (form 1, form 2) Photo CD (single and multiple sessions) CD-DA CD-Extra (CD PLUS) Video-CD CD Text CD-R CD-RW / High Speed CD-RW / Ultra Speed CD-RW Note: A specific application program is necessary to write the formats listed above. supported media required for specific DVD and CD writing speeds. When writing to DVD at 12X, 16X, and 18x use Pioneer-tested media. 1) Forced Ejection Hole If the tray fails to eject when the Eject button is pressed, insert a stiff rod into the hole and push to eject the tray. During normal operation, the eject button should be used to unload the tray. Turn the power to the drive OFF then wait approximately one minute until the disc stops spinning before trying to eject the tray using the Forced Ejection Hole. 2) BUSY Indicator Operation status is indicated as follows: During reading: Lights During writing: Lights 3) Eject Button Press the button to unload / load the disc. 4) Disc Tray Press the Eject button to open the loading tray then place a CD or DVD disc onto the tray with the label facing up. Press the Eject button again or gently push the tray to close and load. Do not attempt to pull out the disc tray forcibly ­ use the Forced Ejection Hole (1). [. . . ] ⷠWhen the mounting screws are loose, the vibrations from a spinning disc may generate a ripping noise. Do NOT use a power supply other than the internal source provided by the PC. [Position] This unit may be installed vertically as well as horizontally. [Disc Size] 12 cm / 8 cm (Drive does not support non-standard shapes such as business cards, diamond, etc. [. . . ]