User manual PIONEER DVR-2920Q

[. . . ] CAUTION: CAUTION: Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. The use of optical instruments with this product will increase eye hazard. This product complies with the EMC Directives (89/336/EEC, amended by 92/31/EEC and 93/68/ECC). Operation is subject to the following two (2) conditions: ( 1 ) This device may not cause harmful interference ( 2 ) This device must accept any interference received, including interference that may cause undesired operation. [. . . ] Improper adjustment of other controls may result in damage and can require extensive work by a qualified technician to restore the unit to its normal operation. When the product exhibits a distinct change in performance ­ this indicates a need for service About DualDisc Playback ­ DualDisc is a new two-sided disc with one side containing DVD video / audio / etc. content and the opposite side containing non-DVD content such as digital audio material. The non-DVD audio side is not compliant with the CD Audio Specification; therefore, may not play. The DVD side of DualDisc media plays in this unit. For more details about the DualDisc specification, please refer t to the disc manufacturer or your retailer. Note: Some discs may not be playable due to different recording formats or the physical condition of the disc at the time of recording or playback. Write Speed (CAV, ZCLV, *** This specification describes the maximum speed in one zone. DVD-Download disc DVD single layer/dual layer / 120 mm / 80 mm (usable only when unit is mounted horizontally) disc DVD-R (when writing, use only 650nm ­ for General use ­ media) DVD-R (4X, 8X, 16X write speed) Dual Layer DVD-R (DL) DVD-RW (1X, 2X, 4X, 6X write speed) DVD+R (2. A specific software application is necessary to write the formats listed above. supported media required for specific DVD and CD writing speeds. Average writing speed may decrease when multiple discs are written during the same session. When writing to DVD at 12X and 16X, use Pioneer-tested media. 1) Forced Ejection Hole If the tray fails to eject when the Eject button is pressed, insert a stiff rod into the hole and push to eject the tray. During normal operation, the eject button should be used to unload the tray. Turn the power to the drive OFF then wait approximately one minute until the disc stops spinning before trying to eject the tray using the Forced Ejection Hole. 2) Disc Tray Press the Eject button to open the loading tray then place a CD or DVD disc onto the tray with the label facing up. Press the Eject button again or gently push the tray to close and load. Do not attempt to pull out the disc tray forcibly ­ use the Forced Ejection Hole (1). 3) BUSY Indicator Operation status is indicated as follows: During reading Lights During writing Lights 4) Eject Button Press the button to unload / load the disc. The region code can only be changed five (5) times, including the initial setting. please be aware that the fifth change becomes PERMANENT. [. . . ] 4) Press smoothly but firmly until the tray protrudes by at least a ½ inch (5 mm to 10 mm). 5) Gently pull the tray straight out and remove the disc. Do not place objects in front of the tray while in operation. [Disc Size] 12 cm / 8 cm (Drive does not support non-standard shapes such as business cards, diamond, etc. [. . . ]