User manual PIONEER DVR-A04 annexe 1

[. . . ] READ INSTRUCTIONS - Read all safety and operating instructions before the Drive is operated. RETAIN INSTRUCTIONS - Retain the safety and operating instructions for future reference. Use only a damp cloth to clean the exterior housing. WATER AND MOISTURE - DO NOT use this product near water. [. . . ] Always be sure to store your discs in proper DVD-R storage cases when not in use, and always be sure to check for dirt or dust on discs (especially on the recording side) before use. Write Speed CLV 1X and 2X at DVD-R CLV 1X at DVD-RW CLV 4X and 8X at CD-R CLV 4X at CD-RW CLV 4X at High speed CD-RW · Note: Specific application program that support above format is needed to write. The region code can be changed ONLY 5 times, including the 1st setting. Please be aware the 5th change will be PERMANENT, therefore, please pay attention when changing region codes. However, Region codes on DVD discs are optional. DVD discs with no specified Region code can be played on all players. Open the loading tray by pressing the eject button, then place a CD or DVD disc into the slit with the label facing up. Press the eject button or push the front part of tray to load the tray with the disc. Do not attempt to pull out the disc tray forcibly. The audio output of rear panel is active even when a jack is inserted into the headphone plug. This is the volume control knob for adjusting sound level on the headphone. When the knob is turned to the right, the headphone volume goes up, when turned to the left, the volume goes down. During reading Lights green During writing Lights orange When an error occurs Blinks orange · Do not block this part. Insert a stiff rod into the hole and push to eject the tray when the tray doesn't unload by pressing the Eject button. In the normal operation, the eject button should be used to unload the tray. Make sure the power of the drive is turned off and wait more than one minute till the disc rotation is stopped when access the eject hole. This connector is compatible with `Molex 70553`, choose a suitable connection cable. Make sure the power of the drive is off before changing jumper setting. pin # 1 is ON at the time of shipping from the plant. Pin 1 2 3 4 5 Name Function MA on The drive is used in master mode. [. . . ] * When loading a disc, the two disc support tabs must be set in the proper position. 15") disc cannot be played even an adapter is attached to the disc when the drive is upright condition. Turn off the power supply of the personal computer. 㷠Connect the power cable from the personal computer. [. . . ]