User manual PIONEER DVR-SK12D

[. . . ] 7 All names of corporations, products, and systems listed herein, even when the (TM) or (®) symbols are omitted, should be considered the registered trademarks of their respective owners. For pluggable equipment the socket-outlet shall be installed near the equipment and shall be easily accessible. Thank you for buying this Pioneer product. Please read through these operating instructions so you will know how to operate your model properly. [. . . ] Do not leave the unit with the disc tray in the open position, since dust may enter the unit causing malfunctions. During use of the component if noise is produced in nearby radios or televisions, separate the radios/television from the component by at least 2 meters (6. 5 feet), or try using different power outlets/circuits for the components. When not using the unit for extended periods, turn off the power, and disconnect the AC power cord from its outlet. For information regarding use of furnished software applications, or in the event of trouble with them, consult the customer service representatives of the respective software companies. Do not affix paper or labels to the disc. Remove dust or lint from the disc with a soft cloth by wiping from the inside to the outside edge rather than in a circular motion. Do not use record-cleaning or anti-static agents as the solutions may cause damage to a disc. Always be sure to store your discs in proper DVD-R storage cases when not in use, and always be sure to check for dirt or dust on discs (especially on the recording side) before use. The region code can be changed ONLY 5 times, including the 1st setting. Please be aware the 5th change will be PERMANENT, therefore, please pay attention when changing region codes. However, Region codes on DVD discs are optional. DVD discs with no specified Region code can be played on all players. Lights orange when an IEEE1394 connection is used. Insert a stiff rod into the hole and push to eject the tray when the tray doesn't unload by pressing the Eject button. In the normal operation, the eject button should be used to unload the tray. Make sure the power of the drive is turned off and wait more than one minute till the disc rotation is stopped when access the eject hole. When set to AUTO, the component turns on automatically in linkage with the ON/ OFF of the computer. The tray may be closed by pressing its front edge in until it stops. Do not attempt to pull out the disc tray forcibly. The following conditions are general recommendations, and do not represent conditions for guaranteed performance. Memory: 128 MB or more (256 MB or more recommended). [. . . ] Check whether the disc is dirty or damaged. Check whether the unit is on a level surface. Turn off the unit and wait awhile before trying again. * For details on how to record discs, see the Help function or the instruction manual supplied with the software. [. . . ]