User manual PIONEER DVR-X162Q

[. . . ] This unit should not be placed in a built-in installation unless properly ventilated. Environment ­ Avoid installing this drive in a location with exposure to large quantities of dust, high temperatures, high humidity, or subject to excessive vibrations or shocks. Power Sources ­ Operate this drive only from the recommended power sources. If you are unsure of the power source, consult an authorized Pioneer representative. [. . . ] Do not affix paper or labels to the disc. Remove dust or lint from the disc with a soft cloth by wiping from the inside to the outside edge rather than in a circular motion. ⷠDo not use record-cleaning or anti-static agents as the solutions may cause damage to a disc. Always be sure to store your discs in proper disc storage cases when not in use, and always be sure to check for dirt or dust on discs (especially on the recording side) before use. Note: Some discs may not be playable due to different recording formats or the physical condition of the disc at the time of recording or playback. DVD-ROM (dual) 12X DVD-R DL, 12X DVD+R DL DVD-RW, DVD+RW 13X DVD-RAM 12X CD-ROM, CD-R 40X CD-RW 32X Buffer Memory Size 2 MBytes (Read/Write) Horizontal / Vertical orientation available Low vibration Mechanism by DRA System DVD Download using recordable CSS technology Disc Format (Read/Write) DVD-Download disc DVD single layer/dual layer / 120 mm / 80 mm (Usable only when unit is mounted horizontally) disc DVD-R (In case of write, 650 nm disc for General only. Notes:A specific application program is necessary to write the formats listed above. supported media required for specific DVD and CD writing speeds. When writing to DVD at 12X, 16X, and 20X use Pioneer-tested media. Com Average writing speed may decrease when multiple discs are written during the same session. 20X write speed with DVD±R is possible when USB high-speed driver is used (this driver allows higher data transmission rates than otherwise possible with USB connections). Note that the USB driver is specific to this device, and will not produce the same results when used with other devices on the same USB port. Likewise, high-speed drivers supplied with other devices will not be effective for increasing the transmission speed of this unit. Forced Ejection Hole If the tray fails to eject when the Eject button is pressed, insert a stiff rod into the hole and push to eject the tray. During normal operation, the eject button should be used to unload the tray. Turn the power to the drive OFF then wait approximately one minute until the disc stops spinning before trying to eject the tray redundant prepositional phrase. BUSY Indicator Operation status is indicated as follows: During reading Lights During writing Lights Eject Button Press the button to unload / load the disc. Disc Tray Press the Eject button to open the loading tray then place a CD or DVD disc onto the tray with the label facing up. Press the Eject button again or gently push the tray to close and load. Do not attempt to forcibly pull out the disc tray ­ use the Forced Ejection Hole . The region code can only be changed five (5) times, including the initial setting. please be aware that the fifth change becomes PERMANENT. [. . . ] Gently pull the tray straight out and remove the disc. Notes: To prevent injury and damage to the unit, do NOT force the tray to open while the disc is spinning. Do not place objects in front of the tray while in operation. [Disc Size] 12 cm / 8 cm (Drive does not support non-standard shapes such as business cards, diamond, etc. [. . . ]