User manual PIONEER F-401 schematics

[. . . ] As the colours of the wires in the mains lead of this appliance may not correspond with coloured markings identifying the terminals in your plug, proceed as follows ; The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black. The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red. Do not connect either wire to the earth terminal of a three pin plug. NOTE After replacing or changing a fuse, the fuse cover in the plug must be replaced with a fuse cover which corresponds to the colour of the insert in the base of the plug or the word that is embossed on the base of the plug, and the appliance must not be used without a fuse cover. [. . . ] This product complies with the Low Voltage Directive (73/23/EEC, amended by 93/68/EEC), EMC Directives (89/336/EEC, amended by 92/31/EEC and 93/68/EEC). d3-4-2-1-9a_En If the AC plug of this unit does not match the AC outlet you want to use, the plug must be removed and appropriate one fitted. Replacement and mounting of an AC plug on the power supply cord of this unit should be performed only by qualified service personnel. if connected to an AC outlet , the cut-off plug can cause severe electrical shock. Make sure it is properly disposed of after removal. The equipment should be disconnected by removing the mains plug from the wall socket when left unused for a long period of time (for example, when D3-4-2-2-1a_A_En on vacation). You can find the voltage selector switch on the bottom plate of the unit. the factory setting for the voltage selector is 220 ­ 240 V. Please set it to the correct voltage for your country or region. Please set to the correct voltage before using. Before changing the voltage, disconnect the AC power cord. Use the BNC plug coaxial cable (furnished with this unit) to connect to player A's SYNC IN connector. Use a S-Video cable (sold separately) to connect to the player B's SVideo VIDEO OUT connector. Use 3 BNC plug coaxial cables (sold separately) to connect to player B's component video output connectors (Y, CB/PB, CR/PR). Use the control cable (furnished with this unit) to connect to the CONTROL connector of the channel that will control the DJ mixer's player A. Player control connector, used to control player, fader start and other operations (minijack x 1). Use the control cable (provided with DVJ-X1) to connect to player B's CONTROL connector. The sync signal is used to synchronize video signals between players A and B, thus preventing video distortion resulting from mix-matched signals when switching between images. Use the BNC plug coaxial cable (furnished with this unit) to connect to player B's SYNC IN connector. Note: In order to produce the various video system outputs, the same input system signals are necessary (the unit does not perform video signal conversion). Composite video output connector for player A or player B as selected by this unit (RCA pin jack). Use the control cable (furnished with this unit) to connect to the CONTROL connector of the channel which will control the DJ mixer's player B. [. . . ] The indicator around the border of the VIDEO A button lights when PLAYER A input has been selected. When pressed to the ON position, the AUTO button indicator lights and when a fader start signal is received from the DJ mixer, inputs are switched automatically. If the VIDEO A or VIDEO B button is pressed manually during the AUTO mode (namely, pressing whichever input button is not currently selected), the input will switch to the one pressed, but the AUTO mode will continue in effect; as a result, when a fader start signal is subsequently received from the DJ mixer, the inputs will automatically switch once again. When the AUTO button is pressed once again to the OFF condition (button indicator goes out), the inputs will not switch even if a fader start signal is received from the DJ mixer. [. . . ]