User manual PIONEER F-F3-J

[. . . ] RISK OF ELECTRIC SHOCK DO NOT OPEN The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. To prevent a fire or shock hazard, do not place any container filled with liquid near this equipment (such as a vase or flower pot) or expose it to dripping, splashing, rain D3-4-2-1-3_A_En or moisture. When installing this unit, make sure to leave space around the unit for ventilation to improve heat radiation (at least 10 cm at top, 10 cm at rear, and 10 cm at each side). Slots and openings in the cabinet are provided for ventilation to ensure reliable operation of the product, and to protect it from overheating. [. . . ] To turn on the power in this case, press either the remote control unit's button or a different button (other than the POWER button) on the main unit. ⷠWhen the unit is in the standby mode, if the power is turned off by unplugging the power cord, the power will not turn merely by reconnecting the power cord. To turn on the power in this case, reconnect the power cord and then press either the remote control unit's button or a different button (other than the POWER button) on the main unit. The unit times out if no operation is performed for about five seconds after the menu mode is set. Turn the dial clockwise to change the reception toward higher frequencies. Turn the dial counterclockwise to tune the reception toward lower frequencies. The auto tuning operation cannot be used when in this mode. When inputting station names, use this dial to select desired characters (page 18). 12 AUTO PRESET When pressed during FM or AM mode, receivable stations are automatically stored in the preset memory in order starting from preset channel A1. 2 Station call buttons (1 to 10) Use these buttons to preset stations, and to recall previously preset stations. This button is also used for manual station-name character selection for FM and AM broadcasts, and for Program Type search. 1 Noise may be generated when receiving AM or FM if a near-by television set is turned on. The tuner should be used as far away from a television as possible. 2 Effective period of memory back-up is about a month under normal temperature. 6 MPX Use to switch between stereo and mono reception during FM broadcasts. If the signal is weak, switching to mono may improve the sound quality (page 15). 7 VOLUME Use to adjust your Pioneer amplifier's sound volume. TUNE When pressed during FM or AM mode, receivable stations are automatically stored in the preset memory in order starting from preset channel A1. Keep in mind the following when using the remote control: · Make sure that there are no obstacles between the remote and the remote sensor on the unit. ⷠThe remote has a range of about 7 m at an angle of about 30º from the remote sensor. ⷠRemote operation may become unreliable if strong sunlight or fluorescent light is shining on the unit's remote sensor. ⷠRemote controllers for different devices can interfere with each other. [. . . ] For an external AM antenna, use 5 m to 6 m of vinyl-insulated wire and set up either indoors or outdoors. 2 This process can be used to form a daisychain linkage with other Pioneer components as well. Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong with this component, check the points below. [. . . ]