User manual PIONEER F-X21ZL

[. . . ] To prevent fire hazard, the openings should never be blocked or covered with items (such as newspapers, table-cloths, curtains) or by operating the equipment on thick carpet or a bed. D3-4-2-1-7b*_A1_En WARNING This equipment is not waterproof. To prevent a fire or shock hazard, do not place any container filled with liquid near this equipment (such as a vase or flower pot) or expose it to dripping, splashing, rain or moisture. D3-4-2-1-3_A1_En WARNING Before plugging in for the first time, read the following section carefully. The voltage of the available power supply differs according to country or region. Be sure that the power supply voltage of the area where this unit will be used meets the required voltage (e. g. , 230 V or 120 V) written on the bottom panel. D3-4-2-1-4*_A1_En WARNING To prevent a fire hazard, do not place any naked flame sources (such as a lighted candle) on the equipment. D3-4-2-1-7a_A1_En WARNING Store small parts out of the reach of children and infants. [. . . ] · It may not be possible to record tracks of audio CDs on a USB device. For details, see When a USB device is connected on page 36. 1. Push the USB terminal cover as shown on the diagram below. 20 En USB playback 06 Recording all the tracks 1 Load the audio CD. · If playback starts automatically, press STOP to stop playback. Only when a CD is in the stop mode, recording can start. · All Clear: Deselect all the tracks. English 5 Use /// to select `Bitrate' (transfer rate), then press ENTER. Select `128kbps', `192kbps' or `320kbps'. 6 Use /// to select `Start', then press ENTER. Note · If recording does not start, confirm this unit's settings on the TV screen. · The audio signals are converted into MP3 format for output. · `CD -> USB Rec' can only be selected when the audio CD is stopped. · When recording is completed, a folder named "PIONEER" is automatically created on the USB device. The tuned frequency will be displayed on the front panel display. 2 Press number button (1 to 9) that is memorized the FM radio station. Tip · Press ST + repeatedly to selected the station preset in numerical order. Memorizing stations You can save up to 9 station presets so that you always have easy access to your favorite stations without having to tune in manually each time. 2 Note 1 To ensure optimum reception, make sure the FM antenna is fully extended and not coiled or hanging at the rear of the unit. 2 When a new broadcast frequency is stored in a station containing a previously stored frequency, the previous frequency will be overwritten with the new one. 22 En Other connections 08 Chapter 8: English Other connections · Before making or changing the connections, switch off the power and disconnect the power cord from the AC outlet. · If the AUX IN mini-plug jack is connected to auxiliary phones jack, this unit's volume will be changed by the playback component's volume. If the sound is distorted after you lower this unit's volume, try lowering the auxiliary playback component's volume. · This unit can not transfer the external input's sound from the HDMI OUT terminal. Digital audio player, etc. Français Stereo mini-plug cable (commercially available) Español Connecting auxiliary components Connect the rear panel AUX IN mini-plug jack to your auxiliary playback component. · This method can be used to play music on this unit from iPod/iPhones that do not support use of an iPod Dock. · Press FUNCTION to switch to AUX input mode. When the AUX input is selected, ` ' is displayed on the front panel display. 23 En 09 Changing the settings Chapter 9: Changing the settings The factory default settings are indicated in italic. [. . . ] Do not use dirty cleaning cloths. · Do not use benzene, thinner or other volatile chemicals. Also do not use record spray or antistatic agents. · For tough dirt, apply some water to a soft cloth, wring out thoroughly, wipe off the dirt, then wipe off the moisture with a dry cloth. · Do not use damaged (cracked or warped) discs. [. . . ]