User manual PIONEER F-X303Z

[. . . ] Be sure that the power supply voltage of the area where this unit will be used meets the required voltage (e. Replacement and mounting of an AC plug on the power supply cord of this unit should be performed only by qualified service personnel. The wires in this mains lead are coloured in accordance with the following code: Blue : Neutral Brown : Live If the plug provided is unsuitable for your socket outlets, the plug must be cut off and a suitable plug fitted. The cut-off plug should be disposed of and must not be inserted into any 13 amp socket as this can result in electric shock. [. . . ] The original sound is modified to resemble the vowel sounds of the human voice. The Jog dial is used to vary the vowel sound coloration. The MIX dial can be used to adjust the levels of the jet + reverb sound and original sound. The MIX dial can be used to adjust the levels of the phase shifter + reverb sound and the original sound. The filter's cutoff frequency is shifted, causing great change in the sound tone. By modulating the original sound in the shape of a sine wave, the resulting sound coloration resembles a ringing bell. The DEPTH dial is used to change the unique coloring of vowel sounds by adjusting the amount of resonance. (When approaching the [MAX] setting, the level of the sound increases. ) ÷ The CHARACTER dial can be used to adjust the reverb effect. Humanizer block Reverb block The DEPTH dial can be used to adjust the amplitude of the sine wave. The CHARACTER dial can be used to adjust the reverb effect. [MIDI START] If this button is pressed when MIDI mode is set to [TRANSMIT], the MIDI start/stop signal is output. Lights steadily with START, and goes out with STOP. [MIDI channel setting (CH SET)] If this button is held depressed when MIDI mode is set to [TRANSMIT] or [RECEIVE], the MIDI indicator flashes and the MIDI setting mode is enabled. Select MIDI communication between computer and other instruments, etc. When this button is set to ON, the audio input connector signals are fed directly to the output connectors, bypassing the effector circuits. When the audio input/output connectors are connected directly in this way, the indicator flashes. If a beat select button is then pressed, the effect is newly synchronized to the corresponding multiple of the BPM (1/ 8, 1/4, 1/2, 3/4, etc. ) , thus allowing one-touch change of the BPM synchronization multiple. In turn, the selected beat select button lights, thus showing to what multiple of the actual BPM the effect is synchronized, as well as the multiple of the time parameter. [During RHYTHM mode] When the rhythm input with the TAP button is established, [1/1] is selected and a multiple of the rhythm can be selected with the beat select buttons. When effects are set to ON, this dial can be used to control the effect output level. [. . . ] Cancel the EFX LINK, and disconnect any digital input with priority over analog inputs. Outputs when BYPASS is selected are as follows: Input connection conditions Analog only Digital only Analog & digital Effect sounds aren't applied. EFFECT FREQUENCY indicators (HI, MID, LOW) are all off (during use of TRANS, FLANGER, FILTER, or PHASER effects). When analog and digital inputs are connected simultaneously, the digital input is given priority. [. . . ]