User manual PIONEER FH-460UI

[. . . ] ователя Italiano Español Deutsch Nederlands Русский <QRD3247-A>1 Black plate (2, 1) Section 01 Before you start Before you start Thank you for purchasing this PIONEER product To ensure proper use, please read through this manual before using this product. It is especially important that you read and observe WARNINGs and CAUTIONs in this manual. Please keep the manual in a safe and accessible place for future reference. About this unit The tuner frequencies on this unit are allocated for use in Western Europe, Asia, the Middle East, Africa and Oceania. [. . . ] W – Select when there is a fullrange speaker connected to the rear speaker leads output and there is a subwoofer connected to the RCA output. W – Select when there is a subwoofer connected directly to the rear speaker leads output without any auxiliary amp and there is a subwoofer connected to the RCA output. REAR/REAR – Select when there is a fullrange speaker connected to the rear speaker leads output and the RCA output. If there is a full-range speaker connected to the rear speaker leads output and the RCA output is not used, you may select either REAR/SUB. Note AUX cannot be selected unless the auxiliary setting is turned on. for more details , refer to AUX (auxiliary input) on page 8. English Switching the display Selecting the desired text information 1 Press DISP to cycle between the following: !Source name and clock If an unwanted display appears Turn off the unwanted display using the procedures listed below. Initial menu 1 Press and hold SRC/OFF until the unit turns off. 2 Press and hold SRC/OFF until the main menu appears in the display. Once selected, the following initial menu functions can be adjusted. System menu 1 Press and hold SRC/OFF until the unit turns off. 2 Press and hold SRC/OFF until the main menu appears in the display. Using an AUX source 1 Insert the stereo mini plug into the AUX input jack. en 9 <QRD3247-A>9 Black plate (10 , 1) Section 03 Installation Installation Connections Important !When installing this unit in a vehicle without an ACC (accessory) position on the ignition switch, failure to connect the red cable to the terminal that detects operation of the ignition key may result in battery drain. Use of this unit in conditions other than the following could result in fire or malfunction. To prevent a short-circuit, overheating or malfunction, be sure to follow the directions below. € Disconnect the negative terminal of the battery before installation. € Secure the wiring with cable clamps or adhesive tape. Wrap adhesive tape around wiring that comes into contact with metal parts to protect the wiring. € Place all cables away from moving parts, such as the shift lever and seat rails. [. . . ] Users of iPod with the Lightning Connector should use the Lightning to USB Cable (supplied with iPod). Users of iPod with the Dock Connector should use CD-IU51. CAUTION Pioneer accepts no responsibility for data lost on the iPod, even if that data is lost while this unit is used. 3 Save the folder containing files on the USB storage device. [. . . ]