User manual PIONEER FH-P6600R

[. . . ] Never feed power to other equipment by cutting the insulation of the power supply lead of the unit and tapping into the lead. When replacing fuse, be sure to use only fuse of the rating prescribed on the fuse holder. Since a unique BPTL circuit is employed, never wire so the speaker leads are directly grounded or the left and right speaker leads are common. Please ground this lead separately from the ground of high-current products such as power amps. [. . . ] In another type of vehicle, never connect 6* and 7*. This product conforms to new cord colors. Cords for this product and those for other products may be different colors even if they have the same function. When connecting this product to another product, refer to the supplied Installation manuals of both products and connect cords that have the same function. Perform these connections when using a different amp (sold separately). Speaker leads White : Front left + White/black : Front left Gray : Front right + Gray/black : Front right Green : Rear left + Green/black : Rear left Violet : Rear right + Violet/black : Rear right ISO connector Note: In some vehicles, the ISO connector may be divided into two. In this case, be sure to connect to both connectors. Yellow/black If you use a cellular telephone, connect it via the Audio Mute lead on the cellular telephone. If not, keep the Audio Mute lead free of any connections. Before finally installing the unit, connect the wiring temporarily, making sure it is all connected up properly, and the unit and the system work properly. Use only the parts included with the unit to ensure proper installation. The use of unauthorized parts can cause malfunctions. Consult with your nearest dealer if installation requires the drilling of holes or other modifications of the vehicle. Install the unit where it does not get in the driver's way and cannot injure the passenger if there is a sudden stop, like an emergency stop. The semiconductor laser will be damaged if it overheats, so don't install the unit anywhere hot -- for instance, near a heater outlet. If installation angle exceeds 30° from horizontal, the unit might not give its optimum performance. Installation using the screw holes on the side of the unit Fastening the unit to the factory radio mounting bracket. Select a position where the screw holes of the bracket and the screw holes of the head unit become aligned (are fitted), and tighten the screws at 3 or 4 places on each side. Use either binding screws (5 × 6 mm) or flush surface screws (5 × 6 mm), depending on the shape of the screw holes in the bracket. Avoid installing this unit in such a location where the operation of safety devices such as airbags is prevented by this unit. Otherwise, there is a danger of a fatal accident. Avoid installing this unit in such a location where the operation of the steering wheel and the gearshift lever may be prevented. [. . . ] If the pawl gets in the way, bend it down. Screw Be sure to use the screws supplied with this product. When removing the remote control unit from the holder, move the corrugated release section toward the steering wheel and slide the remote control unit toward you. Fix this unit securely to the steering wheel with the belt attached to the unit. [. . . ]