User manual PIONEER GEX-P5750TV

[. . . ] â· Refer to the owner's manual for details on connecting the other units, then make connections correctly. To protect the wiring, wrap adhesive tape around them where they lie against metal parts. â· Route and secure all wiring so it cannot touch any moving parts, such as the gear shift, handbrake and seat rails. [. . . ] â· Route and secure all wiring so it cannot touch any moving parts, such as the gear shift, handbrake and seat rails. Do not route wiring in places that get hot, such as near the heater outlet. If the insulation of the wiring melts or gets torn, there is a danger of the wiring short-circuiting to the vehicle body. â· Don't pass the yellow lead through a hole into the engine compartment to connect to the battery. This will damage the lead insulation and cause a very dangerous short. â· Do not shorten any leads. If you do, the protection circuit may fail to work when it should. â· Never feed power to other equipment by cutting the insulation of the power supply lead of the unit and tapping into the lead. â· When mounting this unit, make sure none of the leads are trapped between this unit and the surrounding metalwork or fittings. â· Do not mount this unit near the heater outlet, where it would be affected by heat, or near the doors, where rainwater might splash onto it. Before drilling any mounting holes always check behind where you want to drill the holes. Do not drill into the gas line, brake line, electrical wiring or other important parts. â· If this unit is installed in the passenger compartment, anchor it securely so it does not break free while the car is moving, and cause injury or an accident. â· If this unit is installed under a front seat, make sure it does not obstruct seat movement. Route all leads and cords carefully around the sliding mechanism so they do not get caught or pinched in the mechanism and cause a short circuit. Before installing, use a thin standard tip screwdriver to switch the operation mode switch on this unit to the appropriate position for the component you are using it with. [. . . ] â· If this unit is installed under a front seat, make sure it does not obstruct seat movement. Route all leads and cords carefully around the sliding mechanism so they do not get caught or pinched in the mechanism and cause a short circuit. Before installing, use a thin standard tip screwdriver to switch the operation mode switch on this unit to the appropriate position for the component you are using it with. [. . . ]