User manual PIONEER GM-D8601

[. . . ] ователя Nederlands Русский Section 01 Before you start Thank you for purchasing this PIONEER product To ensure proper use, please read through this manual before using this product. It is especially important that you read and observe WARNINGs and CAUTIONs in this manual. Please keep the manual in a safe and accessible place for future reference. We offer the latest information about PIONEER CORPORATION on our website. [. . . ] 1 POWER/PROTECT indicator The power indicator lights up to indicate power ON. If something is not normal, the indicator turns red. 2 GAIN (gain) control If output remains low, even when the car stereo volume is turned up, turn controls to lower level. Protective function included to prevent malfunction of the unit and/or speakers due to excessive output, improper use or improper connection. , this function cuts off the output for a few seconds as a normal function, but output is restored when the volume of the head unit is turned down. 4 En Section Setting the unit !A cut in sound output may indicate improper setting of the gain control. To ensure continuous sound output with the head unit at a high volume, set amplifier gain control to a level appropriate for the preout maximum output level of the head unit, so that volume can remain unchanged and to control excess output. Despite correct volume and gain settings, the unit sound still cuts out periodically. in such cases , please contact the nearest authorized Pioneer Service Station. Gain control of this unit Preout level: 2 V (Standard: 500 mV) 02 English Signal waveform when outputting at high volume using amplifier gain control Signal waveform distorted with high output, if you raise the gain of the amplifier the power changes only slightly. preout level: 4 V Above illustration shows NORMAL gain setting. Relationship between amplifier gain and head unit output power If amplifier gain is raised improperly, this will simply increase distortion, with little increase in power. en 5 Section 03 Connecting the units Connection diagram 7 2 3 6 4 5 9 8 b c a 1 e h d i j f g 1 Battery wire (sold separately) !The maximum length of the wire between the fuse and the positive + terminal of the battery is 30 cm. For the wire size, refer to Connecting the power terminal on page 8. The battery wire, the ground wire and the optional direct ground wire must be same size. After making all other connections at the amplifier, connect the battery wire terminal of the amplifier to the positive + terminal of the battery. 2 Fuse 100 A (GM-D8601) / 150 A (GM-D9601) (sold separately) Each amplifier must be separately fused at 100 A (GM-D8601) / 150 A (GM-D9601). 3 Positive (+) terminal 4 Negative (*) terminal 5 Battery (sold separately) 6 Ground wire, Terminal (sold separately) The ground wires must be same size as the battery wire. 7 Car stereo with RCA output jacks (sold separately) 8 External output 9 Connecting wire with RCA pin plugs (sold separately) a Amplifier with RCA input jacks (sold separately) b Bass boost level remote control c Bass boost level remote control wire (5 m) d RCA input jack e RCA output jack f System remote control wire (sold separately) Connect male terminal of this wire to the system remote control terminal of the car stereo. The female terminal can be connected to the auto-antenna relay control terminal. [. . . ] 1 Terminal screws 2 Speaker wires 3 Speaker output terminals 2 En 9 Section 04 Installation Before installing the amplifier WARNING !To ensure proper installation, use the supplied parts in the manner specified. If any parts other than those supplied are used, they may damage internal parts of the amplifier, or become loose causing the amplifier to shut down. Do not install in: — Places where it could injure the driver or passengers if the vehicle stops suddenly. [. . . ]