User manual PIONEER HDJ-1500-K

[. . . ] If the vehicle is equipped with a glass antenna, connect it to the antenna booster power supply terminal. Never connect the blue/white cable to the power terminal of an external power amp. Also, never connect it to the power terminal of the auto antenna. Doing so may result in battery drain or a malfunction. [. . . ] For more details on change settings, refer to the operation manual or Switching the DSP setting mode on this page. If using this system, we recommend that this unit’s internal amp is turned off. For details, refer to the operation manual. The speaker leads are not used when this connection is in use. For more details on change settings, refer to the operation manual or Switching the DSP setting mode on this page. The following signals are output from the speaker leads when this connection is in use. White: Middle range left + White/black: Middle range left * Gray: Middle range right + Gray/black: Middle range right * Green: High range left + Green/black: High range left * Violet: High range right + Violet/black: High range right * 1 5   !If using this system, we recommend that this unit’s internal amp is turned off. For details, refer to the operation manual. The speaker leads are not used when this connection is in use. For more details on change settings, refer to the operation manual or Switching the DSP setting mode on this page. Install this unit away from hot places such as near the heater outlet. Optimum performance is obtained when the unit is installed at an angle of less than 60°. 60° 2 Audio input If you connect the unit to an audio device with RCA output, or to one with no RCA output, you can set it up so that the audio from the audio device is output through speakers connected to the unit. Change settings as necessary based on whether the connected device has RCA output or not. For more details on change settings, refer to the operation manual or Switching between RCA input modes on this page. Switching between RCA input modes % Use a thin, flathead screwdriver to change the RCA input mode switch on the bottom of this unit. When installing, to ensure proper heat dispersal when using this unit, make sure you leave ample space behind the rear panel and wrap any loose cables so they are not blocking the vents. 1 Dashboard 2 Mounting sleeve 3 Install the unit as illustrated. 1 3 2 Leave ample 5 cm space 5 cm 5cm cm 4 5 1 2 3 4 5 If connecting the unit to a car stereo with RCA output 1 2 3 4 ! l (Low) - If inputting from the RCA output of a connected device !H (High) - If inputting from the speaker output of a connected device DIN front/rear mount This unit can be properly installed using either front-mount or rear-mount installation. [. . . ] 1 2 Removing the unit 1 Remove the trim ring. 1 Microphone 2 Microphone clip 2 Install the microphone clip on the sun visor. With the sun visor up, install the microphone clip. (Lowering the sun visor reduces the voice recognition rate. [. . . ]