User manual PIONEER HTP-600

[. . . ] 1 2 Open the battery compartment on the rear of the remote control. 3 Connect each speaker to the receiver using the supplied speaker wires. To connect, insert the colored wire into the matching colored (+) tab and the other wire into the black (­) tab as shown below. [. . . ] Note that the color-coded tabs are as follows: · Red : Front right speaker · White : Front left speaker · Green : Center speaker · Purple : Subwoofer · Grey : Surround right speaker · Blue : Surround left speaker Surround right Surround left Speaker cord (x1) INPUT SELECTOR STB DVD/DVR DIGITAL FM/AM TAPE/VCR TV CLASS TUNING STATION ­ SYSTEM SETUP + + ­ + CH LEVEL VOLUME FM wire antenna ROOM SETUP ENTER TEST TONE Insert the supplied batteries following the markings inside the battery compartment to align them correctly. ­ AUTO OFF SURROUND SOUND TONE STEREO MPX 3 4 Batteries (x2) Replace the battery compartment cover. Receiver ­ BASS + ­ TREBLE + RECEIVER AM loop antenna Remote control Brackets (x4) Stick the self-adhesive non-skid pads to the underside of each speaker, and to the underside of the subwoofer. Use four pads per speaker (see below). Listening position R FRONT L CENTER SPEAKERS SUB WOOFER SURROUND R L + + ­ ­ Subwoofer Screws (x4) Non-skid pads (1x20, 1x4) You should also have: · Speakers (x5) · Subwoofer · Operating instructions · Warranty card Front and surround speakers Center speaker Subwoofer For the best surround sound, set up your speakers like this. The front left and right speakers should be about 6­9 feet apart. Front right Center Front left 4 1 2 Connect antennas Connect the FM wire antenna and fully extend along a window frame or another suitable place that gives good reception. To connect the AM loop antenna, twist the exposed wire strands together and insert into the terminal, then snap the connector shut as shown below. 5 1 2 Connect the receiver to your DVD player/ recorder. 6 1 Press Use a coaxial digital cord (not supplied) to connect the digital output of your DVD player/ recorder to the DIGITAL INPUT (COAXIAL) DVD/DVR jack. Make sure that the wall on which you intend to mount the speakers is strong enough to support them. Do not mount on plywood or soft surface walls. Use screws that are suitable for the wall material and that will support the weight of the speaker. ÷ DVD player/ recorder COAXIAL OUT VIDEO OUT Mounting screw (not supplied) 5 mm 10 mm Bracket screw (supplied) 5 ­ 7 mm Not supplied Not supplied ÷ If you are unsure of the material and strength of the walls, consult a professional for advice. Pioneer is not responsible for any accidents or damage that result from improper installation. Not supplied ÷ AUDIO OUT VIDEO IN Subwoofer Front R. DIGITAL INPUT (COAXIAL) DVD/DVR Front L. [. . . ] Center ­ + AUDIO TV IN R FRONT L CENTER SPEAKERS SUB WOOFER SURROUND R L + + ­ ­ Receiver Surround L. [. . . ]