User manual PIONEER HTP-SB510

[. . . ] RISK OF ELECTRIC SHOCK DO NOT OPEN The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. To prevent a fire or shock hazard, do not place any container filled with liquid near this equipment (such as a vase or flower pot) or expose it to dripping, splashing, rain or moisture. Before plugging in for the first time, read the following section carefully. The voltage of the available power supply differs according to country or region. [. . . ] For correct speaker settings, do not adjust the volume during the test tones. The configuration shown on-screen should reflect the actual speakers you have. With error messages (such as Too much ambient noise) select RETRY after checking for ambient noise (see Other problems when using the Auto MCACC Setup on page 53). Try to be as quiet as possible after pressing ENTER. See below for notes regarding background noise and other possible interference. When using surround back speakers, turn on the power to the amplifier to which the surround back speakers are connected, and adjust the sound level to the desired level. If the speaker configuration displayed isn't correct, use / to select the speaker and / to change the setting. When you're finished, go to the next step. If you see an error message (ERR) in the right side column, there may be a problem with the speaker connection. If selecting RETRY doesn't fix the problem, turn off the power and check the speaker connections. note 1 The screensaver automatically starts after three minutes of inactivity. If you cancel the Auto MCACC Setup at any time, the system automatically exits and no settings will be made. 2 MIC IN blinks when the microphone is not connected to MCACC SETUP MIC. 8 Make sure `OK' is selected, then press ENTER. If the screen in step 7 is left untouched for 10 seconds and the ENTER button is not pressed in step 8, the Auto MCACC setup will start automatically as shown below. A progress report is displayed on-screen while the system outputs more test tones to determine the optimum system settings for channel level, speaker distance, and Acoustic Calibration EQ. Other problems when using the Auto MCACC Setup If the room environment is not optimal for the Auto MCACC Setup (too much background noise, echo off the walls, obstacles blocking the speakers from the microphone) the final settings may be incorrect. check for household appliances (air conditioner , fridge , fan , etc. ), that may be affecting the environment and switch them off if necessary. If there are any instructions showing in the front panel display, please follow them. Some older TVs may interfere with the operation of the microphone. If this seems to be happening, switch off the TV when doing the Auto MCACC Setup. [. . . ] IPod (please use the latest iPod software (I/U ERR2) versions later than the iPod updater 200410-20). An iPod not supported by this system is Connect the iPod supported by this connected. IPod/USB Error 3 When there is no response from the iPod. (I/U ERR3) No Track Update the iPod software to the latest version. [. . . ]