User manual PIONEER HTZ-170DVD

[. . . ] Also, the use of this remote control may cause other devices to work improperly. ⷠWhen the operating range of the remote becomes too short, replace the batteries. * In some countries or regions, the shape of the power plug may sometimes differ from that shown in the explanatory drawings. If your listening room is of adequate size, place the speakers as shown in step 3 to achieve the optimum surround sound effect. [. . . ] If any of the bare speaker wire touches the back panel it may cause the power to cut off as a safety measure. ⷠThe front, center and surround speakers supplied with this system are magnetically shielded. However, depending on the installation location, color distortion may occur if the speaker is installed extremely close to the screen of a television set. If this case happens, turn the power switch of the television set OFF, and turn it ON after 15 min to 30 min. If the problem persists, place the speaker system away from the television set. ⷠThe subwoofer is not magnetically shielded and so should not be placed near a TV or monitor. Magnetic storage media (such as floppy discs and tape or video cassettes) should also not be kept close to the subwoofer. ⷠDo not attach the center speaker and subwoofer to the wall or ceiling. Connect each speaker using the color-coded speaker cords. Connect the DVD/CD receiver to your TV, then connect the supplied power cord. The colored wire with the color-coded label (above the tabs), then insert the colored wire into the red (+) tab and the other wire with the black (­) tab. This player is equipped with copy protection technology. Do not connect this player to your TV via a VCR using AV cables, as the picture from this player will not appear properly on your TV. The small lug at the wire-end of the speaker plug should face up or down depending on whether it's being plugged into one of the upper or lower three speaker terminals. For the best surround sound, setup your speakers as above. The front left and right speakers should be about 1. These speaker terminals carry HAZARDOUS LIVE voltage. To prevent the risk of electric shock when connecting or disconnecting the speaker cables, disconnect the power cord before touching any uninsulated parts. [. . . ] Use screws that are suitable for the wall material and that will support the weight of the speaker. caution · If you are unsure of the qualities and strength of the walls, consult a professional for advice. Turn the speakers towards the closest wall, lining the arrows up for optimal Front Surround. For Front Surround mode, turn each surround speaker so that the arrow at the base is lined up with the (FRONT SURROUND) arrow on the front speaker. [. . . ]