User manual PIONEER HTZ180DVD -

[. . . ] RISK OF ELECTRIC SHOCK DO NOT OPEN The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. When installing this unit, make sure to leave space around the unit for ventilation to improve heat radiation (at least 10 cm at top, 10 cm at rear, and 10 cm at each side). Slots and openings in the cabinet are provided for ventilation to ensure reliable operation of the product, and to protect it from overheating. To prevent fire hazard, the openings should never be blocked or covered with items (such as newspapers, table-cloths, curtains) or by operating the D3-4-2-1-7b_A_En equipment on thick carpet or a bed. [. . . ] It is possible to listen to two-channel audio and watch DivX video/WMV/JPEG files using the USB interface on the front of this unit. Make sure your TV is on and set to the correct video input. Important If a USB ERR message lights in the display, it may mean that the power requirements of the USB device are too high for this player, or that the device is incompatible. try the following: · Switch the player off, then on again. Reconnecting the USB device with the player switched off. Selecting to another input source (like DVD/CD), then back to USB. Using a dedicated AC adapter (supplied with the device) for USB power. If this doesn't remedy the problem, it is likely your USB device is incompatible. The tracks of a music CD loaded in this unit can be recorded on a USB connected to the USB port. Make sure USB DATA is showing in the front panel display (or the system is in standby) when disconnecting. It is not possible to connect this unit to a personal computer for USB playback. Pioneer cannot guarantee compatibility (operation and/or bus power) with all USB mass storage devices and assumes no responsibility for any loss of data that may occur when connected to this unit. With large amounts of data, it may take longer for the system to read the contents of a USB device. Some USB devices may not be properly recognized. Even when they are in a supported format, some files may not play or display depending on the content. The screen shown below is displayed during recording. CD -> USB Rec can only be selected when the music CD is stopped. 6 Select `Start' using the ///, then press ENTER. 1 Recording cannot be started if there is not enough free space on the USB device. In this case, "Available USB space is low" is displayed. 2 · When recording is finished, a folder named "PIONEER" is created automatically on the USB device. The recorded tracks are stored in this folder. [. . . ] Depending on the connected equipment, some HDMI Color settings may cause the picture to be displayed incorrectly. In this case, use the TV's own video input settings to select RGB, if possible. Color problems occur with your monitor after changing the HDMI Color setting (page 34). If the problem still persists when connecting your HDMI component directly to your monitor, please consult the component or monitor manual or contact the manufacturer for support. [. . . ]