User manual PIONEER JA-R2S

[. . . ] Operating this unit Head unit CAUTION This product is a class 1 laser product classified under the Safety of laser products, IEC 60825-1:2007, and contains a class 1M laser module. To ensure continued safety, do not remove any covers or attempt to gain access to the inside of the product. If a track number 100 or more is selected, d on the left of the track number indicator will light. Operation is the same as when using the buttons on the head unit. [. . . ] Selecting ROUGH enables you to search every 10 tracks. FF/REV ­ Fast forward and reverse ROUGH ­ Searching every 10 tracks To select FF/REV, press c. If the rest of track number is less than 10, press and hold c or d recalls the first (last) one. After selecting, perform the following procedures to set the audio function. You can also turn loudness on or off by pressing and holding E (EQ/LOUD). SLA (source level adjustment) SLA (Source Level Adjustment) lets you adjust the volume level of each source to prevent radical changes in volume when switching between sources. When selecting FM as the source, you cannot switch to SLA. Settings are based on the FM volume level, which remains unchanged. The AM volume level can also be adjusted with this function. After selecting, perform the following procedures to set the function. BSM (best stations memory) BSM (best stations memory) automatically stores the six strongest stations in the order of their signal strength. -- Cover any disconnected cable connectors with insulating tape. -- Never cut the insulation of the power cable of this unit in order to share the power with other devices. When this unit is on, control signals are sent through the blue/white cable. Connect this cable to the system remote control of an external power amp or the vehicle's auto-antenna relay control terminal (max. If the vehicle is equipped with a glass antenna, connect it to the antenna booster power supply terminal. Never connect the blue/white cable to the power terminal of an external power amp. Also, never connect it to the power terminal of the auto antenna. Doing so may result in battery drain or a malfunction. Use speakers over 50 W (output value) and between 4 W to 8 W (impedance value). Do not use 1 W to 3 W speakers for this unit. When installing this unit or power amp (sold separately), make sure to connect the ground wire first. [. . . ] Releasing the front panel allows easier access to the trim ring. When reattaching the trim ring, point the side with the notched tab down. Select the repeat The repeat play Depending on play range again. Range changes the repeat play unexpectedly. [. . . ]