User manual PIONEER KEH-P1010R

[. . . ] Refer to the owner's manual for details on connecting the power amp and other units, then make connections correctly. To protect the wiring, wrap adhesive tape around them where they lie against metal parts. [. . . ] When an external power amp is being used with this system, be sure not to connect the blue/white lead to the amp's power terminal. Likewise, do not connect the blue/white lead to the power terminal of the auto-antenna. To avoid short-circuiting, cover the disconnected lead with insulating tape. Especially, insulate the unused speaker leads without fail. There is a possibility of short-circuiting if the leads are not insulated. If this unit is installed in a vehicle that does not have an ACC (accessory) position on the ignition switch, the red lead of the unit should be connected to a terminal coupled with ignition switch ON/OFF operations. If this is not done, the vehicle battery may be drained when you are away from the vehicle for several hours. Cords for this product and those for other products may be different colors even if they have the same function. When connecting this product to another product, refer to the supplied Installation manuals of both products and connect cords that have the same function. IP-BUS cable Multi-CD player (sold separately) IP-BUS input (Blue) Note: Depending on the kind of vehicle, the function of 3* and 5* may be different. In this case, be sure to connect 2* to 5* and 4* to 3*. Cap (1*) When not using this terminal, do not remove the cap. [. . . ] (Install as firmly as possible using the top and bottom tabs. Insert the supplied extraction keys into the unit, as shown in the figure, until they click into place. [. . . ]