User manual PIONEER KEH-P16

[. . . ] Take extra care in securing the wire at this point. It is extremely dangerous to allow the display lead to become wound around the steering column or gearshift. Be sure to install the display in such a way that it will not obstruct driving. Make sure that wires will not interfere with moving parts of the vehicle, such as the gearshift, parking brake or seat sliding mechanism. [. . . ] When you connect the separately sold multi-channel processor (DEQ-P6600) to this unit, do not connect anything to the speaker leads and system remote control (blue/white). When you connect the multi-channel processor to this unit, refer to multi-channel processor's installation manual for the connection method. Perform these connections when using the optional amplifier. When connecting with a rear view camera When connecting with a multi-channel processor When this product is used with a rear view camera, it is possible to automatically switch from the video to rear view image when the gear shift is moved to REVERSE (R). Please contact your dealer to inquire about the connectable navigation unit. In this case, be sure to connect 1* to 4* and 3* to 2*. The rear view camera function is to be used as an aid for backing into a tight parking spot. Do not use this function for entertainment purposes. Objects in the rear view may appear closer or more distant than they actually are. Violet/white Of the two lead wires connected to the back lamp, connect the one in which the voltage changes when the gear shift is in the REVERSE (R) position. This connection enables the unit to sense whether the car is moving forwards or backwards. -- it may cause injury to a passenger as a result of a sudden stop. Do not install the display where it may (i) obstruct the driver's vision, (ii) impair the performance of any of the vehicle's operating systems or safety features, including air bags, hazard lamp buttons or (iii) impair the driver's ability to safely operate the vehicle. Install this unit away from hot places such as near the heater outlet. Optimum performance is obtained when the unit is installed at an angle of less than 30°. And then secure the mounting sleeve by using a screwdriver to bend the metal tabs (90°) into place. This unit can be properly installed either from "Front" (conventional DIN Front-mount) or "Rear" (DIN Rear-mount installation, utilizing threaded screw holes at the sides of unit chassis). Use commercially available parts when installing. When installing the optical cable connection box with the hook and loop fastener. Install the optical cable connection box using the hook and loop fastener in the ample space of the console box. Install this unit using only the parts supplied with this unit. If other parts are used, this unit may be damaged or could dismount itself, which leads to an accident or other problems. [. . . ] If you do not plan to detach the front panel, the front panel can be fastened with supplied screw. The cords must not cover up the area shown in the figure below. This is necessary to allow the amplifires to radiate freely. Fasten with the lock tie Do not cover this area. [. . . ]