User manual PIONEER KEH-P20

[. . . ] Do not operate this navigation system if doing so in any way will divert your attention from the safe operation of your vehicle. Traffic restrictions and advisories currently in force should always take precedence over guidance given by this product. Always obey current traffic restrictions, even if this product provides contrary advice. This manual explains how to install this navigation system in your vehicle. [. . . ] Use speakers over 50 W (output value) and between 4 W to 8 W (impedance value). Do not use 1 W to 3 W speakers for this unit. Please earth this lead separately from the earth of high-current products such as power amps. Do not earth more than one product together with the earth from another product. For example, you must separately earth any amp unit away from the earth of this navigation system. Connecting earths together can cause a fire and/or damage the products if their earths became detached. When replacing the fuse, be sure to only use a fuse of the rating prescribed on this product. When disconnecting a connector, pull the connector itself. Do not pull the lead, as you may pull it out of the connector. This product cannot be installed in a vehicle without ACC (accessory) position on the ignition switch. Since a unique BPTL circuit is employed, do not directly earth the * side of the speaker lead or connect the * sides of the speaker leads together. If this connection is made incorrectly or omitted, certain functions of your navigation system will be unusable. You can change the RCA output of the subwoofer depending on your subwoofer system. Never install this product in places where, or in a manner that: -- It could injure the driver or passengers if the vehicle stops suddenly. -- It may interfere with the driver's operation of the vehicle, such as on the floor in front of the driver's seat, or close to the steering wheel or gearstick. Make sure there is nothing behind the dashboard or panelling when drilling holes in them. Be careful not to damage fuel lines, brake lines, electronic components, communication wires or power cables. When using screws, do not allow them to come into contact with any electrical lead. Vibration may damage wires or insulation, leading to a short circuit or other damage to the vehicle. To ensure proper installation, be sure to use the supplied parts in the manner specified. If any parts are not supplied with this product, use compatible parts in the manner specified after you have the parts' compatibility checked by your dealer. If parts other than supplied or compatible ones are used, they may damage internal parts of this product or they may work loose and the product may become detached. [. . . ] -- Places that may be splashed by rain, for example close to the door. Install this navigation system in an area strong enough to bear its weight. Choose a position where this navigation system can be firmly installed, and install it securely. If this navigation system is not securely installed, the current location of the vehicle cannot be displayed correctly. [. . . ]