User manual PIONEER KRP-S04

[. . . ] Do not attach these speakers to the wall or ceiling. about the input · In order to prevent damage to the speaker system resulting from input overload, please observe the following precautions: · Do not connect these speakers to anything other than the specified flat panel display. Be sure to turn the connected devices off and remove the power cord from the wall outlet beforehand when changing the connection or installation method. When using a tone control function to greatly emphasize treble sounds, do not use excessive amplifier volume. [. . . ] Connect the other end of the speaker cables to the rear of flat panel display (see next page). Connect the cable with a red connector to R (right) terminal and the cable with a white connector to L (left) terminal of the flat panel display. When you release the lever, it clamps onto the speaker cable. press and hold the lever when removing the cable. How to connect the speaker cables (flat panel display) Insert the speaker cable connector securely into the panel's speaker terminal. To remove the speaker cable, hold and push the lever then remove it. Before connecting the speakers to the flat panel display, unplug the panel from the power outlet. Connecting the speaker cable with the power cord plugged in can cause malfunction or damage to the panel if the cable's bare wire touches other equipment. Plug in the power cord after connecting the speakers. Inserting it in an angle will result in a faulty connection and no sound may come out of the speaker. If no sound comes out of the speaker, reinsert the cable. If you insert the speaker cable too far so that the insulation is touching the speaker terminal, you may not get any sound. Check if the ends of the speaker cables are securely connected to the terminals by slightly tugging on the cables after making connections. Loose connections may result in sound dropouts or noise. If there is a short in the and cables caused by an exposed lead wire, excessive load may be applied to the flat panel display, resulting in interrupted operation or malfunction. Incorrect connections of the speaker cable to the left or right flat panel display terminals with respect to polarity may result in insufficient stereo sound effects, delivering poor bass sounds or unstable sound image. Do not connect any devices to the speaker terminals other than the speakers specified. Excessive force exerted on the speaker cable may cause connection failures, sound dropouts and/or connector damage. Follow the steps below to attach the cable clamp, an accessory of the flat panel display. 1 ) Thread the clamp band through the holder and bundle the cable(s) in the cable clamp. 2 ) Push and hold the levers then insert the hook into an appropriate hole on the rear of the flat panel display. When using the wall mount unit: NOTE: First lay the flat panel display on top of a soft sheet etc. [. . . ] Operating Instructions (this document) × 1 NOTE: Specifications and design subject to possible modification without notice, due to improvements. If you want to dispose this product, do not mix it with general household waste. There is a separate collection system for used electronic products in accordance with legislation that requires proper treatment, recovery and recycling. Private households in the member states of the EU, in Switzerland and Norway may return their used electronic products free of charge to designated collection facilities or to a retailer (if you purchase a similar new one). [. . . ]