User manual PIONEER MEH-P7100R

[. . . ] If you do, the protection circuit may fail to work when it should. Never feed power to other equipment by cutting the insulation of the power supply lead of the unit and tapping into the lead. When replacing fuse, be sure to use only fuse of the rating prescribed on the fuse holder. [. . . ] ISO connector Note: In some vehicles, the ISO connector may be divided into two. In this case, be sure to connect to both connectors. : Front left + : Front left : Front right + : Front right : Rear left + or Not used : Rear left or Not used : Rear right + or Subwoofer + : Rear right or Subwoofer Yellow/black If you use a cellular telephone, connect it via the Audio Mute lead on the cellular telephone. If not, keep the Audio Mute lead free of any connections. Power amp (sold separately) Front output Blue/white To system control terminal of the power amp (max. In another type of vehicle, never connect 6* and 7*. Use this for connections when you have the separately available amplifier. Note: When a subwoofer is connected to this unit instead of a rear right speaker, do not connect the rear left speaker lead to anything. Before finally installing the unit, connect the wiring temporarily, making sure it is all connected up properly, and the unit and the system work properly. Use only the parts included with the unit to ensure proper installation. The use of unauthorized parts can cause malfunctions. Consult with your nearest dealer if installation requires the drilling of holes or other modifications of the vehicle. Install the unit where it does not get in the driver's way and cannot injure the passenger if there is a sudden stop, like an emergency stop. The semiconductor laser will be damaged if it overheats, so don't install the unit anywhere hot -- for instance, near a heater outlet. If installation angle exceeds 30° from horizontal, the unit might not give its optimum performance. Holder After inserting the holder into the dashboard, then select the appropriate tabs according to the thickness of the dashboard material and bend them. [. . . ] Otherwise, it disturbs driving stability, causing a traffic accident. Always attach this unit to the inner circumference of the steering wheel as shown. When the unit is installed on a right-hand-drive car, the horizontal positions are inverted. [. . . ]