User manual PIONEER MVH-8250

[. . . ] Thank you for purchasing this PIONEER product. To ensure proper use, please read through this manual before using this product. It is especially important that you read and observe WARNINGs and CAUTIONs in this manual. Please keep the manual in a safe and accessible place for future reference. [. . . ] Up or down to adjust the output level of the subwoofer. High Pass Filter (high pass filter adjustment) When you do not want low sounds from the subwoofer output frequency range to play from the front or rear speakers, turn on the HPF (high pass filter). Only frequencies higher than those in the selected range are output from the front or rear speakers. SLA (source level adjustment) SLA (Source Level Adjustment) lets you adjust the volume level of each source to prevent radical changes in volume when switching between sources. When selecting FM as the source, you cannot switch to SLA. Settings are based on the FM volume level, which remains unchanged. Before adjusting source levels, compare the FM volume level with the level of the source you wish to adjust. The AM volume level can also be adjusted with this function. You cannot select Custom1 and Custom2 when using the auto-equalizer. Operation is complete even if the menu is cancelled before being confirmed. After selecting, perform the following procedures to set the system function. Brightness--Contrast--Color--Hue--Dimmer --Temperature--Black Level For details about the settings, refer to Changing the picture adjustment on page 34. Temperature can be adjusted from +3 to ­3. The language can be changed for the following: !If the embedded language and the selected language setting are not the same, text information may not be displayed properly. Some characters may not be displayed properly. To complete this operation, switch the ignition key off and on after you set this setting. Detach Warning (warning tone setting) If the front panel is not detached from the head unit within four seconds of turning off the ignition, a warning tone sounds. AUX Input (auxiliary input) Activate this setting when using an auxiliary device connected to this unit. After selecting, perform the following procedures to set the entertainment function. BGP1 (background picture 1)--BGP2 (background picture 2)--BGP3 (background picture 3) --BGV (background visual)--Photo (photo)-- SPEANA (spectrum analyzer)--Off (display off) 3 Press M. If you select USB, SD as the source, you cannot select Slide Show. [. . . ] MP3 Supply of this product only conveys a license for private, non-commercial use and does not convey a license nor imply any right to use this product in any commercial (i. Revenuegenerating) real time broadcasting (terrestrial, satellite, cable and/or any other media), broadcasting/streaming via internet, intranets and/ or other networks or in other electronic content distribution systems, such as pay-audio or audio-on-demand applications. A small fluorescent tube is used inside the display to illuminate the LCD screen. -- The fluorescent tube should last for approximately 10 000 hours, depending on operating conditions. [. . . ]