User manual PIONEER MVH-X560BT

[. . . ] ователя Italiano Español Deutsch Nederlands Русский <QRD3242-A>1 Black plate (2, 1) Section 01 Before you start Before you start Thank you for purchasing this PIONEER product To ensure proper use, please read through this manual before using this product. It is especially important that you read and observe WARNINGs and CAUTIONs in this manual. Please keep the manual in a safe and accessible place for future reference. About this unit The tuner frequencies on this unit are allocated for use in Western Europe, Asia, the Middle East, Africa and Oceania. [. . . ] CUSTOM2 is a shared setting used in common for all sources. To cycle between the following: Equalizer band—Equalizer level 5 Turn M. 5KHZ—8KHZ Equalizer level: +6 to –6 LOUDNESS (loudness) Loudness compensates for deficiencies in the lowfrequency and high-frequency ranges at low volume. W (subwoofer on/off setting) This unit is equipped with a subwoofer output which can be turned on or off. W CTRL (subwoofer adjustment) Only frequencies lower than those in the selected range are outputted from the subwoofer. To cycle between the following: Cut-off frequency—Output level—Slope level Rates that can be adjusted will flash. HPF SETTING (high pass filter adjustment) Use this function when wanting to listen only to high-frequency sounds. Only frequencies higher than the high-pass filter (HPF) cutoff are output from the speakers. To cycle between the following: Cut-off frequency—Slope level 3 Turn M. Once selected, the following functions can be adjusted. En 11 <QRD3242-A>11 Black plate (12, 1) Section 02 Using this unit Using this unit SLA (source level adjustment) This function prevents the volume from changing too dramatically when the source switches. Settings are based on the FM volume level, which remains unchanged. The MW/LW volume level can also be adjusted with this function. Each of the below combinations are set to the same setting automatically. To select the segment of the clock display you wish to set. 12H (12-hour clock)—24H (24-hour clock) INFO DISPLAY (sub information) The type of text information displayed in the sub information section can be toggled. The signal bar indicator displays for SPEANA or LEVEL METER when the source is set to RADIO. AUTO PI (auto PI seek) The unit can automatically search for a different station with the same programming, even during preset recall. AUX (auxiliary input) Activate this setting when using an auxiliary device connected to this unit. You can also change the dimmer setting by pressing and holding /DIMMER. BRIGHTNESS (brightness adjustment) You can use this setting to adjust the display brightness. The range of settings available for BRIGHTNESS will vary depending on whether DIMMER is on or off. [. . . ] This unit is compatible with the following profiles. 1 USB storage device Playback sequence is the same as recorded sequence in the USB storage device. To specify the playback sequence, the following method is recommended. 1 Create a file name that includes numbers that specify the playback sequence (e. [. . . ]