User manual PIONEER N-50-K

[. . . ] Use in other areas may result in poor reception. The RDS (radio data system) function only works in areas that broadcast RDS signals for FM stations. Do not attempt to install or service this product by yourself. Installation or servicing of this product by persons without training and experience in electronic equipment and automotive accessories may be dangerous and could expose you to the risk of electric shock, injury or other hazards. [. . . ] To invert the order of names in the phone book. To use a Bluetooth audio player with this unit, refer to this manual and the manual for your device for operating instructions. As the signal from your cellular phone may cause noise, avoid using it when you are listening to songs on your Bluetooth audio player. The sound of the Bluetooth audio player will be muted when the phone is in use. When the Bluetooth audio player is in use, you cannot connect to a Bluetooth telephone automatically. Playback continues even if you switch from your Bluetooth audio player to another source while listening to a song. Depending on the type of Bluetooth audio player you have connected to this unit, operation and information display may not be available for some functions. Setting up for Bluetooth audio Before you can use the Bluetooth audio function you must set up the unit for use with your Bluetooth audio player. You will need to pair this unit with your Bluetooth audio player. 10 En <QRD3211-B>10 Black plate (11, 1) Section Using this unit Using this unit 02 1 Connection Use the Bluetooth telephone connection menu. refer to Connection menu operation on page 9. To cycle between the following: Cut-off frequency—Output level—Slope level Rates that can be adjusted will flash. HPF SETTING (high pass filter adjustment) Use this function when wanting to listen only to high-frequency sounds. Only frequencies higher than the high-pass filter (HPF) cutoff are output from the speakers. To cycle between the following: Cut-off frequency—Slope level 3 Turn M. Cut-off frequency: OFF—50HZ—63HZ—80HZ —100HZ—125HZ—160HZ—200HZ Slope level: –12— –24 SLA (source level adjustment) This function prevents the volume from changing too dramatically when the source switches. Settings are based on the FM volume level, which remains unchanged. The MW/LW volume level can also be adjusted with this function. Each of the below combinations are set to the same setting automatically. Adjustment range: +4 to –4 LANGUAGE (multi-language) This unit can display the text information from a compressed audio file even for information embedded in English, Russian or Turkish. If the embedded language and the selected language setting are not the same, text information may not display properly. Some characters may not be displayed properly. [. . . ] Users of iPod with the Lightning Connector should use the Lightning to USB Cable (supplied with iPod). Pioneer accepts no responsibility for data lost on the iPod, even if that data is lost while this unit is used. Sequence of audio files The user cannot assign folder numbers and specify playback sequences with this unit. ) M3u playlist: Not compatible MP3i (MP3 interactive), mp3 PRO: Not compatible USB storage device Playable folder hierarchy: up to eight tiers (A practical hierarchy is less than two tiers. [. . . ]