User manual PIONEER ND-BC2

[. . . ] A rear view camera is a camera that provides symmetrical images in the same way as rear and side view mirrors. Connection to a TV with an RCA video input is possible, but confirm whether the TV you use has a reverse gear connection function. Direct sunlight or strong light (sunlight reflected from a bumper etc) on the camera may result in smear above and below the location where the light strikes, but this is not a malfunction. This product is designed to supplement the driver' s rear view, but the camera images do not show all dangers and obstacles. [. . . ] Do not perform installation in rain or fog. When humidity is high, dry the surface to which the unit is to be attached before installing. Moisture on the attachment surface reduces adhesive strength which may lead to the unit coming off. If the temperature of the attachment surface is low, warm with a hair dryer of other means before installing to improve adhesive strength. Do not attach the camera stand to areas on the car body treated with fluorocarbon resin, or glass. This may result in the rear view camera falling off. During the 24-hour period after installing: ­ Do not apply water to the unit. Thoroughly clean where tape is used for sticking on the unit. Peel off the sheet on the back of they camera stand and stick it on. Press the camera stand with your fingers to stick it to the installation surface. Touching the adhesive surface or sticking the unit on a second time reduces adhesive power which may result in the unit coming off. Glass surface Make sure it doesn't touch the wiper Install on the center part Clean the surface to which the rear view camera is to be installed. Use a cloth or other item to wipe oil, wax, dust and any other dirt from the installation surface. Camera stand When sticking to the center When attaching using camera stand bracket (attaching while rotating by 90°) The camera stand can be installed in various ways by changing the direction in which camera stand bracket is attached or attaching camera stand bracket . Angle of view Horizontal: 135° Angle of view Vertical: 100° Bumper or rear edge of car Remove the rear view camera from the camera stand. Top Rear view camera Bottom Installation screw Camera stand Affix the Velcro tape (hard type) to the bottom of the power supply unit, and affix the Velcro tape (soft type) to the mounting location. Handling the cord on this product or cords associated with accessories sold with the product may expose you to chemicals listed on proposition 65 known to the State of California and other governmental entities to cause cancer and birth defects or other reproductive harm. Route the cables as shown in the figure so that they do not become entangled. Attach the camera stand while being careful not to mistake the vertical orientation of the rear view camera. Adjust the camera stand so that there is no space between it and the installation surface. Power supply unit Velcro tape (hard type) Velcro tape (soft type) Attach the camera stand removed in step 2 to the rear view camera with the mounting screws. Attach the camera stand while being careful not to mistake the vertical orientation of the rear view camera. [. . . ] Specifications and the design are subject to possible modification without prior notice due to improvements. Make a U-shaped loop in the lead outside the rubber packing to prevent rainwater from flowing along the lead into the interior of the vehicle. When pulling the cord out of the car, pull from the outer side of the hatch harness cover and hinge. Pull out from here Hinge Harness cover Rear view camera Hatch Cords for this product and those for other products may be different colors even if they have the same function. [. . . ]