User manual PIONEER ND-BC6

[. . . ] € This product is designed to supplement the driver’s rear view, but the camera images do not show all dangers and obstacles. Be sure to look behind you when reversing to confirm the view. € This product features a wide-angle lens, so the near view is wide and the far view is narrow, which may create a false sense of distance. Be sure to look behind you when reversing to confirm the view. [. . . ] € Do not subject the camera to unnecessary force. € Thoroughly clean where tape is used for sticking on the unit. Adjust the angle so that the bumper or rear edge of the car is displayed at the bottom of the TV screen. 9) Affix the Hook and loop fastener (hard type) to the bottom of the power supply unit, and affix the Hook and loop fastener (soft type) to the mounting location. • • • • Installation example (Fig. 1) ① Glass surface ② Make sure it doesn’t touch the wiper ③ Install on the center part Exemple d’installation (Fig. • • • • Installation example (Fig. € Use only the parts included with the unit to ensure proper installation. The use of unauthorized parts can cause malfunctions. € Consult with your nearest dealer if installation requires the drilling of holes or other modifications of the vehicle. € Install the unit where it does not get in the driver’s way and cannot injure the passenger if there is a sudden stop, like an emergency stop. € When mounting this unit, make sure none of the leads are trapped between this unit and the surrounding metalwork or fittings. € To prevent electric shock, do not install the power supply unit in places where it might come in contact with liquids. € Do not mount this unit near the heater outlet, where it would be affected by heat, or near the doors, where rainwater might splash onto it. (Never install in locations such as the above because of the danger of malfunction due to high temperatures. ) • Before drilling any mounting holes always check behind where you want to drill the holes. Do not drill into the gas line, brake line, electrical wiring or other important parts. € If this unit is installed in the passenger compartment, anchor it securely so it does not break free while the car is moving, and cause injury or an accident. € If this unit is installed under a front seat, make sure it does not obstruct seat movement. Route all leads and cords carefully around the sliding mechanism so they do not get caught or pinched in the mechanism and cause a short circuit. € You can use Hook and loop fastener (hard type) to attach directly to a carpet, but do not use the soft type. € Install the power supply unit close enough for the rear view camera cable to reach. [. . . ] Scuff plate Clamp Waterproof pad Attach the waterproof pad using doublesided tape. ‘ Rear view camera ⑤ Hatch ③ Rubber packing ④ Make a U-shaped loop in the lead outside the rubber packing to prevent rainwater from flowing along the lead into the interior of the vehicle. Attach the waterproof pad using double-sided tape. Note: Specifications and the design are subject to possible modification without prior notice due to improvements. [. . . ]