User manual PIONEER PD-S705

[. . . ] The voltage of the available power supply differs according to country or region. Be sure that the power supply voltage of the area where this unit will be used meets the required voltage (e. g. , 230V D3-4-2-1-4_En or 120V) written on the rear panel. The STANDBY/ON switch is secondary connected and therefore, does not separate the unit from mains power in STANDBY position. Therefore install the unit suitable places easy to disconnect the MAINS plug in case of the accident. The MAINS plug of unit should be unplugged from the wall socket when left D3-4-2-2-2a_En unused for a long period of time. TCUDORP RESAL 1 SSALC D3-4-2-1-8_En CAUTION This product contains a laser diode of higher class than 1. [. . . ] From this screen, only the recording stop time can be changed. 3 Set a new Stop time for the timer recording. Use the / (cursor left/right) buttons to select the hour or minute field, then use the / (cursor up/down) buttons to change the time. 49 En 06 Recording Timer recording FAQ Frequently Asked Questions · Even though the timer is set, the recorder doesn't start recording!Check that the disc loaded is recordable, not locked (see Lock Disc on page 68), and that there are fewer than 99 titles already on the DVD. · The recorder won't let me enter a timer program!You can't enter a timer program if the clock isn't set. · What happens when two or more timer programs overlap?Basically, the program with the earlier recording start time has priority. However, the recorder will start recording the program with the later start time after the earlier program is finished. If two programs have the same times (but different channels, for example), the program set most recently takes priority. · I entered a timer program, but the recorder doesn't confirm whether or not it's OK. The current input is shown on-screen and in the front panel display: · L1 ­ Input 1/Auto Start Rec · L2 ­ Input 2 (front panel) · L3 ­ Input 3 Check that the Audio In settings for External Audio, Dual Mono Recording are as you want them (see Audio In settings on page 78). · If the aspect ratio is distorted (squashed or stretched), adjust on the source component or your TV before recording. · Use REC MODE to set the recording quality. See Setting the picture quality/recording time on page 43 for detailed information. Important · It takes a little while for this recorder to switch on and start recording after detecting a signal. Please bear this in mind when setting the timer. · If Auto Start Recording is set, it will not start if another timer recording is in progress. · Timer recordings take precedence over Auto Start Recording. Auto Start Recording will stop if a timer recording is due to start. After the timer recording has finished, Auto Start Recording will resume. 1 Set the timer for the satellite receiver (or other component), then switch it into standby (if necessary). Check the manual that came with the receiver if you're not sure how to do this. [. . . ] . 0. 68 W (Front panel display: off) Weight . 420 (W) x 59 (H) x 339 (D) mm Operating temperature . . +5°C to +35°C Operating humidity . . NTSC / PAL-N/ PAL-M Recording Recording format . [. . . ]