User manual PIONEER PDA-4004

[. . . ] Thank you very much for purchasing this PIONEER product. Before using this unit, please carefully read the "Safety Precautions" and these "Operating Instructions" so you will know how to operate the Plasma Display properly. This product is marketed assuming that it is installed by qualified personnel with enough skill and competence. Always have an installation specialist or your dealer install and set up the product. [. . . ] The video card and terminal panel are not designed for repeated installation and removal. accordingly , once they have been installed on the plasma display , avoid removing them. Repeated installation and removal may cause them to break. (The screw is constructed so that it cannot be separated from the cover. 3 Install the video card to the four bosses so that the connectors are at the bottom. Make sure that the four bosses retain the circuit board firmly and there is no fear of board separation. 4 Plug the internal wires into the connectors. Make sure that the connector is inserted firmly and completely up to the root. 2 Fit the circuit boad between the slits at each end of the opening. 3 Insert the terminal panel straight and push it in all the way. 4 Make sure that the terminal panel is inserted firmly and completely to the bottom, then secure the terminal panel using the screws removed in step 1 above. The buttons on the main unit and remote control unit, and the external control commands are not accepted by the display unit while the standby indicator is flashing in red. If the optional video card (PDA-4004) is not installed properly, the STANDBY indicator blinks as described below to inform the use of abnormality. Blinking twice Only the terminals are installed: Install the video card. Blinking three times Only the video card is installed: Install the terminals. Each time press changes the input source as follows: To choose an input source with the remote control, press the INPUT SELECT button. " is displayed if the signal being input cannot be processed on this set. The standby indicator flashes in red for about 4 seconds, then remains lit (standby state). 2 Turn off the MAIN POWER switch on the main unit. The STANDBY/ON indicator will dim and the power to the unit will be turned off. [. . . ] Adjusts the contrast of the picture according to the brightness of the environment so that you can watch the picture easier. Adjusts the brightness of the picture so that you can watch the darker parts of the picture, (such as night scenes and dark hair), easier. (Set it to a little lower position than that you want, to obtain natural pictures. Adjusts the tint of the picture so that the face color looks natural. [. . . ]