User manual PIONEER PDA-5002

[. . . ] If you lose the fuse cover the plug must not be used until a replacement cover is obtained. A replacement fuse cover can be obtained from your local dealer. If the fitted moulded plug is unsuitable for your socket outlet, then the fuse shall be removed and the plug cut off and disposed of safely. There is a danger of severe electrical shock if the cut off plug is inserted into any 13 amp socket. [. . . ] 1 Simplified wiring Connections to a Pioneer plasma Television are performed by a single HDMI cable. No need to connect numerous cables from input components to plasma television. Even when a plasma television is wall-mounted, only a single HDMI cable needs to be placed through the wall (when a computer is not connected). Flexible support when changing or adding new input components, even when a plasma television is wallmounted. 2 PDP-linked operation* When set to use HDMI Control function to link this unit and a plasma television, the plasma television's remote control can be used to control this unit as well. This unit's power on/off control can be linked to the power on/off of the plasma television. (To use linked power off, set the plasma television's power off control setting. ) · The plasma television's remote control unit can be used to change inputs on this unit. * When HDMI control is set to ON /when using a supported plasma television (see accompanying table). 3 Support for plasma television's image quality control * When HDMI Control function is activated to support linkage on both this unit and plasma television, it becomes possible to set this unit's inputs to the same image quality settings possible on the plasma television. * When HDMI control is set to ON /when using a supported plasma television (see accompanying table). When using the HDMI Control function, set the rear panel HDMI CONTROL switch to ON, then use the plasma television's "HDMI Control Setting" menu to set the television to permit control of the unit. This unit can also be used as an AV selector, without using the HDMI Control function. in that case , leave the HDMI CONTROL switch set to OFF. This unit has three operating modes when using the Pioneer HDMI Control function. Each of the modes can be ascertained by looking at the status of the HDMI CONTROL indicators. HDMI Control function used for linked operation with Pioneer plasma television. Change input selections INPUT 1 to INPUT 5 using the remote control unit furnished with the Pioneer plasma television. Power on/off linked to plasma television using the remote control unit furnished with the Pioneer plasma television. When a video signal is received from a connected input component, this unit is automatically turned on and the input selector switched to allow output of the image from the connected component (HDMI inputs only). operation restrictions: · The INPUT button on PDA-5002 and its remote control unit are disabled. HDMI Control setting Settings required on this unit: HDMI CONTROL switch: ON Settings required on the Pioneer plasma television: Set to allow linked operation with this unit. [. . . ] If the HDMI CONTROL indicator is lighted green (during PDP combination mode), it the component connected to may not be possible to display the output from INPUT 6. Confirm whether your input component supports HDCP Depending on the input component, it may not be possible to make . If the input component does not support the HDCP standard, use one of the other connection methods, either VIDEO, S-VIDEO, RGB, or COMPONENT. If you do not know the specifications of the input component, consult the component's manufacturer. [. . . ]