User manual PIONEER PDA-H03

[. . . ] , be sure to consult your Pioneer dealer first. WARNING: The apparatus is not waterproofs, to prevent fire or shocks hazard, do not expose this apparatus to rain or moisture and do not put any water source near this apparatus, such as vase, flower pot, D3-4-2-1-3_En cosmetics container and medicine bottle etc. This product complies with the EMC Directives (89/336/EEC, D3-4-2-1-9b_En amended by 92/31/EEC and 93/68/EEC). Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. [. . . ] Using pliers, twist the clamp 90° and pull it outward. In some cases the clamp may have deteriorated over time and may be damaged when removed. Bunch separated cables together and secure them with the provided bead bands. Do not allow excessive stress to be placed on the ends of cables. The onscreen display language has been set to English as the factory default. To change to another language, the screen setting must be changed. Follow the procedures below to change the setting. Use the 5/ buttons to select [LANGUAGE], then press the SET button. The STANDBY indicator on the front panel will light red. Press the STANDBY/ON button to turn the power ON. The ON indicator on the front panel will light green. Before you begin, make sure you have: ⷠMade connections between the plasma display and AV components or personal computer as described in the section "Installation and Connections" starting on page 6. ⷠSet up the on-screen menu to input signals from components connected to INPUT1, INPUT2 and INPUT5 as described in the section "System Settings" starting on page 18. If no connections are made to these terminals, on-screen setup is not necessary. When the menu screen is displayed, changing the signal input will cause the menu screen to turn off. ⷠIf the input computer signal is not supported by the display, the following message will be displayed: Use VOLUME (+/­) buttons on the remote control unit or the display to adjust the sound volume. If no audio connections are made to the plasma display, this step is not necessary. When viewing is finished, press the STANDBY/ON button to put the display in standby mode. set the rear panel MAIN POWER switch to OFF. The STANDBY indicator may continue to light for a short while even after the main power is turned off. This is a result of residual electric load impressed on the circuitry, and the light will turn off presently. The STANDBY indicator on the front panel will light red. [. . . ] 㷠If the input changes when the unit is in [AUTO FUNCTION] mode, pressing the INPUT button to select a different input will cause the [AUTO FUNCTION] mode to be temporarily disabled, but it can be enabled again by turning the power OFF/ ON. When finished with the setting, press the MENU button to return to the normal screen image. The [AUTO FUNCTION] for [INPUT1] is supported only when a separate SYNC or Composite SYNC analog RGB signal is input ([AUTO FUNCTION] is disabled when a G ON SYNC or component video signal is input). The signal level produced at the AUDIO (OUTPUT) jack can be set to [FIXED] or [VARIABLE] (linked to the VOLUME) as desired. [. . . ]