User manual PIONEER PDA-V100HD

[. . . ] Replacement and mounting of an AC plug on the power supply cord of this unit should be performed only by qualified service personnel. This appliance is supplied with a moulded three pin mains plug for your safety and convenience. Should the fuse need to be replaced, please ensure that the replacement fuse has a rating of 13 amps and that it is approved by ASTA or BSI to BS1362. If the plug contains a removable fuse cover, you must ensure that it is refitted when the fuse is replaced. [. . . ] When installing, allow enough space on the sides and above the unit. Do not block the side ventilation opening or the rear exhaust opening of the unit. 2 Load the supplied two AA size batteries while inserting their respective negative polarity (­) ends first. Ventilation opening Over 10 cm Exhaust opening Placing the unit alone in the vertical position can result in product damage and malfunction. Caution Improper use of batteries can result in chemical leakage or an explosion. Be sure to follow the instructions below. When you replace the batteries, use manganese or alkaline ones. Do not mix batteries of different types. Different types of batteries have different characteristics. Mixing old and new batteries can shorten the life of new batteries or cause chemical leakage in old batteries. Remove batteries as soon as they have worn out. Chemicals that leak from batteries can cause a rash. If you find any chemical leakage, wipe thoroughly with a cloth. The batteries supplied with this product may have a shorter life expectancy due to storage conditions. If you will not use the remote control unit for an extended period of time, remove the batteries from it. Operate the remote control unit while pointing it toward the remote control sensor ( ) located at the left of the front panel of the unit. The distance from the remote control sensor must be within 7 m and the angle relative to the sensor must be within 30 degrees in the right, left, upward, or downward direction. Do not expose the remote control unit to shock. In addition, do not expose the remote control unit to liquids, and do not place in an area with high humidity. Do not install or place the remote control unit under direct sunlight. The remote control unit may not work properly if the remote control sensor of the unit is under direct sunlight or strong lighting. In such case, change the angle of the lighting or unit, or operate the remote control unit closer to the remote control sensor. [. . . ] Sound is heard, but no video · No sound (HDMI, VIDEO, SVIDEO, RGB, COMPONENT) No sound (HDMI) · Using a cable to convert from · Video images from analog inputs are not displayed properly. If distortion occurs in the input component's video signal (like when performing fast forward), depending on the video quality, some distortion may appear, or the image may cease to appear properly. the same symptoms may also appear depending on the performance of the television. Also check the following settings on this unit: · If too distant from the receiver, move closer. [. . . ]